American Standard Providence 24" Vanity with Wood Top 9424.200 Montage- und Installationsanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Montage- und Installationsanleitung für Inneneinrichtung American Standard Providence 24" Vanity with Wood Top 9424.200 herunter. American Standard Providence 24" Vanity with Wood Top 9424.200 4 Seiten. American standard providence 24" vanity with wood top assembly & installation instructions

Seite drucken

VANITY INSTALLATION

Provide suitable reinforcement required for anchoring the vanity to the wall. Centerline of reinforcement should be 32-

1/2" up from the floor (see Figure 1).

Back legs are set inward from the rear of the vanity which allows the vanity to sit flush against the wall over most types of

molding. If the vanity interferes with the molding, the molding needs to be notched to seat the vanity flush against the

wall (see Figure 2).

Rough in supply lines and waste per rough in dimensions.

NOTE: If current supply lines are greater than 6" on center, they may interfere with cutout in rear of vanity or vanity shelf.

Remove the wood top from the vanity. The top is held in place from the underside by 4 screws, 1 through each of the 4

angled corner braces.

Move the vanity into place and level with the adjustable glides on the bottom of the feet. The glides can be adjusted

outward up to 1" but it is recommended not to exceed 1/2" if possible. Anchor it to the wall through at least 2 of the

anchoring holes in the rear of the vanity (see Figure 2).

Continue with installation appropriate for top and sink options chosen.

C/L of 2 x 6

Reinforcement

32-1/2"

FIGURE 1

Finished

Floor

Wood Top with Recommended Sinks...

Two people recommended for this installation

Determine which sink is being installed and follow the instructions printed on the

appropriate template supplied with vanity.

NOTE: American Standard is not responsible for cut-out errors when the

incorrect cut-out template is used.

If Installing:

Use Template:

Sebring 0573

730541-400

Coventry 0575

730542-400

After top is replaced, connect the trap to the drain assembly hand tight to check

alignment. It may be necessary to cut off part of the tailpiece (area "A") or part

horizontal leg of the trap (area "B").

Connect hot and cold supply lines to the shut off valves. Tighten trap joints for

watertight assembly.

FIGURE 2

ADJUSTABLE GLIDES

(LOCATED UNDER

EACH FOOT)

WOOD VANITY TOP

IMPORTANT: BE SURE TO CENTER SINK

CUT OUT HORIZONTALLY ON VANITY TOP.

- 2 -

21-1/2"

546mm

ANCHORING

HOLES

MOLDING

PAPER TEMPLATE

73 0 5 4 5 - 1 0 0 R e v. C

32-1/2"

826mm