American Standard Providence 24" Vanity with Wood Top 9424.200 Montage- en installatie-instructies - Pagina 2
Blader online of download pdf Montage- en installatie-instructies voor {categorie_naam} American Standard Providence 24" Vanity with Wood Top 9424.200. American Standard Providence 24" Vanity with Wood Top 9424.200 4 pagina's. American standard providence 24" vanity with wood top assembly & installation instructions
VANITY INSTALLATION
Provide suitable reinforcement required for anchoring the vanity to the wall. Centerline of reinforcement should be 32-
1/2" up from the floor (see Figure 1).
Back legs are set inward from the rear of the vanity which allows the vanity to sit flush against the wall over most types of
molding. If the vanity interferes with the molding, the molding needs to be notched to seat the vanity flush against the
wall (see Figure 2).
Rough in supply lines and waste per rough in dimensions.
NOTE: If current supply lines are greater than 6" on center, they may interfere with cutout in rear of vanity or vanity shelf.
Remove the wood top from the vanity. The top is held in place from the underside by 4 screws, 1 through each of the 4
angled corner braces.
Move the vanity into place and level with the adjustable glides on the bottom of the feet. The glides can be adjusted
outward up to 1" but it is recommended not to exceed 1/2" if possible. Anchor it to the wall through at least 2 of the
anchoring holes in the rear of the vanity (see Figure 2).
Continue with installation appropriate for top and sink options chosen.
C/L of 2 x 6
Reinforcement
32-1/2"
FIGURE 1
Finished
Floor
Wood Top with Recommended Sinks...
Two people recommended for this installation
Determine which sink is being installed and follow the instructions printed on the
appropriate template supplied with vanity.
NOTE: American Standard is not responsible for cut-out errors when the
incorrect cut-out template is used.
If Installing:
Use Template:
Sebring 0573
730541-400
Coventry 0575
730542-400
After top is replaced, connect the trap to the drain assembly hand tight to check
alignment. It may be necessary to cut off part of the tailpiece (area "A") or part
horizontal leg of the trap (area "B").
Connect hot and cold supply lines to the shut off valves. Tighten trap joints for
watertight assembly.
FIGURE 2
ADJUSTABLE GLIDES
(LOCATED UNDER
EACH FOOT)
WOOD VANITY TOP
IMPORTANT: BE SURE TO CENTER SINK
CUT OUT HORIZONTALLY ON VANITY TOP.
- 2 -
21-1/2"
546mm
ANCHORING
HOLES
MOLDING
PAPER TEMPLATE
B
A
73 0 5 4 5 - 1 0 0 R e v. C
32-1/2"
826mm