Da-Lite Contour Electrol Gebrauchsanweisung - Seite 4
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Projektionsfläche Da-Lite Contour Electrol herunter. Da-Lite Contour Electrol 8 Seiten. Installer friendly features
Auch für Da-Lite Contour Electrol: Gebrauchsanweisung (13 seiten), Gebrauchsanweisung (9 seiten), Handbuch für Installateure (2 seiten), Gebrauchsanweisung (4 seiten), Gebrauchsanweisung (8 seiten)
Seite drucken
Electrical Installation
Internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the
left end of the screen case.
Standard installation is for a single 120VAC or 240VAC wall switch to control the screen. Optional Control units may have been ordered.
Wiring diagrams for the built-in VPI and low voltage control are included in these instructions. Refer to additional instructions for the
external VPI, external low voltage control, SCB-100 and SCB-200. Refer to the appropriate wiring diagram for your screen.
120V Wiring Diagram
For Standard
Wall Switch
Junction Box
Located In Left Endcap
SPDT Switch with
Center Off
Up
Off
Down
This Switch Can Not
be used with LVC.
240V Wiring Diagram
For Standard
Wall Switch
Junction Box
Located In Left Endcap
Rear or DPDT Switch
with Center Off
Up
Off
Down
4
Black
Red
NOTE: A single switch cannot be used to operate more
than one screen. Contact the factory for further information.
Brown
BLUE JUMPER
WIRE
Black
This Switch Can Not
be used with LVC.
White
Black
Red
Green
Ground To Case
Ground-Must Be Connected
To Building Ground
AC (Common)
AC HOT 120VAC 60HZ 1 AMP
Black/Yellow
Blue
Brown
Black
Green
Ground To Case
Ground-Must Be Connected
To Building Ground
Brown and Yellow AC HOT
220/240 VAC 50HZ 2 AMP.
Blue AC (Common)
NOTE: A single switch cannot be used to operate more
than one screen. Contact the factory for further information.
Motor
MOTOR