Da-Lite Contour Electrol Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Projektionsfläche Da-Lite Contour Electrol herunter. Da-Lite Contour Electrol 8 Seiten. Installer friendly features
Auch für Da-Lite Contour Electrol: Gebrauchsanweisung (13 seiten), Gebrauchsanweisung (9 seiten), Handbuch für Installateure (2 seiten), Gebrauchsanweisung (4 seiten), Gebrauchsanweisung (8 seiten)

Screen Adjustment

Screen travel is stopped automatically in the down and up

positions by the limit switches that are preset at the factory.

If it's necessary to adjust for more or less drop follow the steps

below. The case cover must be removed to access the motor

limit switches.

Remove the case cover screw from both ends of the screen.

See figure 4. Be sure to hold the cover while removing the

screws.

Rotate the cover up and away from the case until it can

be removed.

SETTING THE DOWN LIMIT POSITION

To Reduce Screen Drop: Turn the red limit switch screw

clockwise to decrease the amount of screen drop. Run the

screen down to test the stop position. If the screen drops too far,

raise the screen about one foot and adjust the limit switch again.

Repeat until the desired position is set.

To Increase Screen Drop: Turn the red limit switch screw

counterclockwise to increase the amount of screen drop. Run the

screen down to test the stop position. If the screen does not

drop enough, raise the screen about one foot and adjust the limit

switch again. Repeat until the desired position is set.

CAUTION: Do not adjust for more drop than what was

ordered. At least 1-1/2 wraps of fabric must remain on the

roller. This screen comes standard with 0" or 2" black at

top. See the specification data sheet for details.

ATTENTION! N'effectuez pas de réglage pour obtenir un

déroulement supérieur à celui commandé. Au moins 1 à 1/2

tour de toile doit être maintenu sur le cylindre. Cet écran est

doté de série d'une bande noire supérieure de 0 cm (0 po) ou

5 cm (2 po). Consultez la fiche technique pour plus de

renseignements.

Figure 4

Hook

Rotate Up

Figure 5

Case Cover

Screw