Dongcheng DJX03-255 Betriebsanleitung Handbuch - Seite 10
Blättern Sie online oder laden Sie pdf Betriebsanleitung Handbuch für Säge Dongcheng DJX03-255 herunter. Dongcheng DJX03-255 14 Seiten. Electric mitre saw
Seite drucken
Compound Cutting
Compound cutting is the process in which a bevel angle is made at the same time
in which a miter angle is being cut on a workpiece. Compound cutting can be
performed at angle shown in the following table.
Bevel Angle
45°
When performing compound cutting, refer to the instructions of "Miter Cutting"
and "Bevel Cutting".
Cutting Aluminum Extrusion
CAUTION:
Never attempt to cut thick or round aluminum extrusions. Thick aluminum
extrusions may come loose during operation and round aluminum extrusions
cannot be secured firmly with this tool.
Use a cutting lubricant when cutting
the aluminum extrusion to prevent
build-up of the aluminum material on
the blade.
Use spacer blocks or pieces of scrap
to
prevent
deformation
of
the
aluminum when securing aluminum
extrusions. (Fig. 22)
MAINTENANCE AND INSPECTION
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to
Miter Angle
Left and Right 0-45°
-17-
perform inspection or maintenance.
Always keep the blade sharp and clean for the best and safest performance.
Adjust the Cutting Angle
This tool is carefully adjusted and aligned before leaving the factory, but rough
handling may have affected the alignment. If the tool is not aligned properly, perform
the following to readjust:
Miter Angle
Loosen the grip which secures the turn
base. Turn the turn base so that the pointer
points to the 0° on the miter scale. Tighten
the grip and loosen the hex bolts securing
the guide fence with the socket wrench.
(Fig. 23)
Lower the handle fully and lock it in the
lowered position by pushing in the stopper
pin. Square the side of the blade with the
face of the guide fence using a triangular
rule, try square, etc. Then securely tighten
the hex bolts on the guide fence in the
order from the right side. (Fig. 24)
Bevel Angle
a) 0° Bevel Angle
Lower the handle fully and lock it in the
lowered position by pushing in the
stopper pin. Loosen the lever at the
rear of the tool.
-18-