Dongcheng DJX03-255 Betriebsanleitung Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Betriebsanleitung Handbuch für Säge Dongcheng DJX03-255 herunter. Dongcheng DJX03-255 14 Seiten. Electric mitre saw
Seite drucken
Securing Workpiece
CAUTION:
Always be sure to secure the workpiece properly and tightly with the vise.
Failure to do so can cause the tool to be damaged and/or the workpiece to be
destroyed. PERSONAL INJURY MAY ALSO RESULT.
DO NOT raise the blade until the blade has come to a complete stop after each
cutting operation.
Shifting Dam
This tool is equipped with the shifting
dam. It should be positioned as shown
in Fig. 15.
Be sure to flip the dam over to the left
position when performing left bevel
cuts. (Fig. 16)
Vertical Vise
CAUTION:
Always secure the workpiece firmly against the turn base and guide fence with
the vise during all operations.
When cutting long workpieces, use supports that are as high as the top surface
level of the turn base. Do not rely solely on the vertical vise to secure the
-13-
workpiece. (Fig. 17)
Thin material tends to sag. Support
workpiece over its entire length to avoid
blade pinch and possible KICKBACK.
The vertical vise can be installed in two
positions on either the left or right side of
the guide fence or the holder assembly
(optional accessory). Insert the vise rod
into the hole in the guide fence or the
holder assembly and tighten the screw to secure the vise rod.
Position the vise arm according to the thickness and shape of the workpiece and
secure the vise arm by tightening the screw. If the screw to secure the vise arm
contacts the guide fence, install the screw on the opposite side of vise arm. Make sure
that no part of the tool contacts the vise
when lowering the handle all the way. If
some part contacts the vise, re-position the
vise.
Press the workpiece flat against the guide
fence and the turn base. Position the
workpiece at the desired cutting position
and secure it firmly by tightening the vise
knob. (Fig. 18)
Holder Assembly
CAUTION:
Always support long workpieces level
with the top surface of the turn base for
accurate cuts and to prevent dangerous
loss of control of the tool.
Use the holder assembly when cutting long
-14-