Astonica 40201048 Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Außen-Brunnen Astonica 40201048 herunter. Astonica 40201048 2 Seiten. Large rock water fountain

Seite drucken

PARTS & HARDWARE LIST

PART #

DESCRIPTION

Rock Basin

Electric Pump

Fountain

Rocks

Parts Detail

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

ELECTRICAL SAFETY INSTRUCTIONS

WARNING!

ELECTRICAL SHOCK. Read and understand all instructions. Failure to follow all

instructions listed below, may result in electrical shock, ﬁre and/or serious personal injury.

QUANTITY

1. (SEE FIGURE 1) Connect the clear tube on the

fountain (C) to the pump spout (B), making sure

the tube is fully seated on the spout.

2. Connect the plug on the fountain (C) to the plug

on the pump (B), feeding through the hole in the

side of the basin. Set the pump and fountain

assembly into the basin (A).

3. Fill the basin (A) with water. If possible, use

distilled water to avoid mineral build up in

fountain.

4. Arrange rocks on top of the assembled fountain

as desired.

5. Plug power cord into properly grounded 12V AC

outlet.

Adjust Speed of Water Flow

1. Unplug pump (B) from AC power outlet.

2. Move adjustment switch on pump (B)

toward "+" positive to increase water

ﬂow, or "-" to decrease water ﬂow.

Maintenance

1. Check water level periodically, add

water if necessary.

2. If water is not ﬂowing, check electric pump (B),

and fountain (A) water pipe for clogs.

NOTE: Pump may build up calcium after a

long period of time and stop running when

tap water is used. Any calcium remover can

be used to clean pump.

Outdoor Use Extension Cords

1. When product is used outdoors, use only extension cords marked for outdoor use.

2. Use only UL listed extension cords. Never use damaged or altered extension cords.

3. Follow extension cord manufacturer safety instruction.

Extension Cords

1. Make sure your extension cord is in good condition.

2. When using extension cords, be sure to use one heavy enough to carry the current your product

requires. An undersized cord will cause a drop in line voltage resulting in power loss and

overheating. Reference Table 1 below for the correct size to use depending on cord length and

nameplate Ampere rating. If in doubt, use the next heavier gage. The smaller

the gage number, the heavier the cord.

Table 1. Minimum Recommended Extension Cord Gauge (AWG) Chart

ASSEMBLY INSTRUCTIONS

Figure 1

Grounded

Outlets

AMP Load

Volts Extension Cord Length

120V

25'

50'

100'

AWG

1-5

6-10

10-12

12-16

Not recommended

150'