Astonica 40201048 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Fontanna zewnętrzna Astonica 40201048. Astonica 40201048 2 stron. Large rock water fountain

Drukuj stronę
Astonica 40201048 Instrukcja obsługi
PARTS & HARDWARE LIST
PART #
PART #
DESCRIPTION
A
Rock Basin
B
Electric Pump
C
Fountain
D
Rocks
Parts Detail
A
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ELECTRICAL SAFETY INSTRUCTIONS
WARNING!
ELECTRICAL SHOCK. Read and understand all instructions. Failure to follow all
instructions listed below, may result in electrical shock, fire and/or serious personal injury.
QUANTITY
1
1
B
D
C
1
1. (SEE FIGURE 1) Connect the clear tube on the
fountain (C) to the pump spout (B), making sure
the tube is fully seated on the spout.
2. Connect the plug on the fountain (C) to the plug
1
on the pump (B), feeding through the hole in the
1
side of the basin. Set the pump and fountain
assembly into the basin (A).
3. Fill the basin (A) with water. If possible, use
distilled water to avoid mineral build up in
fountain.
4. Arrange rocks on top of the assembled fountain
as desired.
5. Plug power cord into properly grounded 12V AC
outlet.
Adjust Speed of Water Flow
1. Unplug pump (B) from AC power outlet.
2. Move adjustment switch on pump (B)
toward "+" positive to increase water
flow, or "-" to decrease water flow.
Maintenance
1. Check water level periodically, add
water if necessary.
2. If water is not flowing, check electric pump (B),
and fountain (A) water pipe for clogs.
NOTE: Pump may build up calcium after a
long period of time and stop running when
tap water is used. Any calcium remover can
be used to clean pump.
Outdoor Use Extension Cords
1. When product is used outdoors, use only extension cords marked for outdoor use.
2. Use only UL listed extension cords. Never use damaged or altered extension cords.
3. Follow extension cord manufacturer safety instruction.
Extension Cords
1. Make sure your extension cord is in good condition.
2. When using extension cords, be sure to use one heavy enough to carry the current your product
requires. An undersized cord will cause a drop in line voltage resulting in power loss and
overheating. Reference Table 1 below for the correct size to use depending on cord length and
nameplate Ampere rating. If in doubt, use the next heavier gage. The smaller
the gage number, the heavier the cord.
Table 1. Minimum Recommended Extension Cord Gauge (AWG) Chart
ASSEMBLY INSTRUCTIONS
Figure 1
C
B
Grounded
Outlets
AMP Load
Volts Extension Cord Length
120V
25'
50'
100'
AWG
1-5
18
16
16
6-10
18
16
14
10-12
14
14
14
12-16
14
12
Not recommended
2
C
D
A
B
150'
14
12
12