AMERITRON SDC-102 Gebrauchsanweisung - Seite 5
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Controller AMERITRON SDC-102 herunter. AMERITRON SDC-102 13 Seiten. Screwdriver antenna controller
Seite druckenSDC-102 Screwdriver Controller with Memory
1.
The red wire needs to be fused and connected to the vehicle's +12
VDC supply. The size of the fuse depends upon the current requirement
of the antenna motor. Typically a 5 Amp slow-blow fuse will work.
Some installations may require additional wire. Use 16 AWG wire to
add additional length.
2.
The black wire needs to be connected to the vehicle (station) ground.
If the supplied red and black wires are not long enough, Use 16 AWG
wire to add additional length.
3. Connect the 4 pin Molex to the antenna.
Antennas that do not have a 4 pin plug. The plug can be cut
off. Use the chart below for wire color and its function.
CONTROL CABLE
BLACK
GREEN
WHITE
WARNING: An RF choke must be placed around the control lines at
the antenna. The Controller may be damaged if an RF
choke is not used.
Motor Operating Voltage
This control unit is designed to operate with a screwdriver antenna that operates
on 12 volts. Many antennas operate on only 3 or 4 volts, a Dropping Resistor
can be used inline with the motor wires to bring the voltage down. Consult your
antenna manual or manufacturer for the operating voltage.
© 2006 Ameritron
Instruction Manual
motor control
RED
MOTOR WIRE
MOTOR WIRE
SENSOR
SENSOR
3