AMERITRON SDC-102 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengontrol AMERITRON SDC-102. AMERITRON SDC-102 13 halaman. Screwdriver antenna controller

SDC-102 Screwdriver Controller with Memory

The red wire needs to be fused and connected to the vehicle's +12

VDC supply. The size of the fuse depends upon the current requirement

of the antenna motor. Typically a 5 Amp slow-blow fuse will work.

Some installations may require additional wire. Use 16 AWG wire to

add additional length.

The black wire needs to be connected to the vehicle (station) ground.

If the supplied red and black wires are not long enough, Use 16 AWG

wire to add additional length.

3. Connect the 4 pin Molex to the antenna.

Antennas that do not have a 4 pin plug. The plug can be cut

off. Use the chart below for wire color and its function.

CONTROL CABLE

BLACK

GREEN

WHITE

WARNING: An RF choke must be placed around the control lines at

the antenna. The Controller may be damaged if an RF

choke is not used.

Motor Operating Voltage

This control unit is designed to operate with a screwdriver antenna that operates

on 12 volts. Many antennas operate on only 3 or 4 volts, a Dropping Resistor

can be used inline with the motor wires to bring the voltage down. Consult your

antenna manual or manufacturer for the operating voltage.

Instruction Manual

motor control

RED

MOTOR WIRE

SENSOR