Flycam DSLR-NANO-QR-BL Montageanleitung - Seite 6
Blättern Sie online oder laden Sie pdf Montageanleitung für Kamera-Zubehör Flycam DSLR-NANO-QR-BL herunter. Flycam DSLR-NANO-QR-BL 10 Seiten. Dslr nano blue handheld camera stabilizer
Seite drucken
NOTE:
When adding weight to the cups, use
the supplied foam spacers as silencers to pre-
vent metal-to-metal washer noise.
VERTICAL STALK ADJUSTMENT
Vertical Adjustment of the telescopic central
post is made by loosening the control at the
base, raising or lowering the post to the
desired location, and then re-tightening the
vertical control. Do not over-tighten this
control.
Balancing Your Flycam Stabilizer
Before beginning the balancing process check the following:
•
Camera is securely attached to Head Plate
•
Lens cap is removed and secured
•
Telescoping Clamp is tightened
•
Weight discs are added successfully
•
All screws are tightened securely
•
Battery, all accessories and cables are secured
Balancing the Horizontal Axis
When your FLYCAM DSLR Nano is properly assembled, you can start the test and setup of the horizontal
balance. Horizontal balance allows the camera to remain level during operation with the Central Post in
a vertical position unless off-axis framing is desired. Testing for horizontal balance starts from a flat and
level surface like a table, allowing the FLYCAM DSLR Nano to hang free as you hold it. If your FLYCAM
DSLR Nano is correctly balanced on its horizontal axis, then it will be both level & upright, with the
Central Post in a perfectly vertical position.
Warning: If you do not have enough weight on the Base Platform, the entire Flycam could flip upside
down. If this movement starts to happen, be ready to catch the stalk before a complete 180 occurs. This
type of unwanted movement requires more weight to be added to the base with additional weight
discs.
Another way to accomplish Horizontal Balance is to move the center of gravity of camera by
re-mounting the camera to a different area of the Head and Mid Plate, either front-to-back or
side-to-side.
If the FLYCAM DSLR Nano is front heavy, loosen the screws on the sides of the Head Plate and gently
slide the Head Plate back until the optimum balance is achieved. Tilting to the back means the load is
tail heavy requiring the plate to be adjusted forward on the head.
6