Akw M17 DigiPump Installations- und Pflegeanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Installations- und Pflegeanleitung für Water Pump Akw M17 DigiPump herunter. Akw M17 DigiPump 20 Seiten. Digipump

Seite drucken

Commissioning Checks

As a general precaution and check before installation, always ensure the supply pipework

to the shower has been fully purged with at least 20 litres (2 buckets) of water through it

before the flow sensor is installed. Any building debris in the water supply will adversely

affect the sensor function and may also damage the shower heater/mixer.

Install pump according to these instructions. Failure to do so may void warranty.

Confirm all push-fit pipes are fully inserted 20mm into fittings.

Brush out all dust, grit and debris

from shower tray

Thoroughly clean out waste

Confirm shower water supply pipework is flushed

before connecting to the shower sensor via the filter

Turn on power to Pump

Turn shower on Low Flow and confirm pump

operates after Start Delay (default 5 secs.)

Run for 2-3 mins

Set shower to Maximum Flow

Follow the Calibration setting, adjust pump speed on

controller to match maximum shower flow

Switch shower OFF.

Pump will RUN-ON

Adjust RUN-ON and repeat until tray is cleared and

pump stops with minimum RUN-ON

If you experience problems see

Problem Solving section