Coldelite UC-113G Handbuch - Seite 16

Blättern Sie online oder laden Sie pdf Handbuch für Gefrierschrank Coldelite UC-113G herunter. Coldelite UC-113G 17 Seiten. Gravity soft serve freezers

Seite drucken

When the portion is the size you want, close the handle and

The outer tube is actually a valve. Rotating it from hole to hole

pull the cup or cone straight down to add a peak.

on the outer tube varies the size of the hole and the amount of

Typical portion sizes are: SMALL = 3 OUNCE SERVING

MEDIUM

5 OUNCE SERVING

LARGE = 7 OUNCE SERVING

mix that flows into the freezing cylinder. The size of the alr

inlet, at the top of the tube, does not change so the amount of

air that enters the freezing cylinder is constant.

You can vary the overrun (yield) by letting more or less mix

enter the freezing cyl~nder by manually regulating the valve.

You must align the mix inlet holes on both the inner and outer

tubes or no mix will enter the cylinder. You can see this hole at

the top of both tubes. See illustration below.

Figure 1 2

Gravity Feed Tube Adjustment Settings

The plunger/splash guard keeps the mix from splashing on the

mix tank cover and serves as a device to eliminate potent~al

clogging inside the tubes

You may find it necessary to.adjust the position of the outer

Gravity Feed Valve

HOW to

tube in order to regulate the amount of mix entering the

Operate and Make Adjustments

freezing cylinder after start-up. Actually, sales conditions will

dictate the proper adjustment.

The Gravity Feed Valve consists of two tubes. one slid~rlg inside

If more production is required, increase the opening by rotating

the other, and a plungerlsplash guard.

the outer tube to a laraer hole, and converselv when business

The inner tube blends the flow of air and mix into the freezing

is slow, rotate to a smaller hole on the outer tube, reducing the

cylinder. Air enters through the top of the tube and the mlx.

opening. Naturally, when the mix runs low in the mix tank, you

through a round hole at the base. See illustration below

will open the slot more and eventually take the feed tube out

completely to use the last of mix in the mix tank.

Energy Conservation

During long idle periods. it is recammended the outer sleeve of

the gravity feed tube be rotated to the position which closes

the mix intake hole completely.

IMPORTANT. Remember to rotate the outer tube to the appro-

priate opening Sefore switching to the AUTO mode.

For further Operational or Technical Data, please refer to the

"Operation and Service Manual" or contact your authorized

Coldelite Distributor or Service Agency.

All technical data, pictures and drawings contained in this

leaflet are not binding on the manufacturer; nor can the

manufacturer be held liable for any modification of the machine

in part or completely.

Figure 11