Asus AT3GC-I NA SI Benutzerhandbuch - Seite 18

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Hauptplatine Asus AT3GC-I NA SI herunter. Asus AT3GC-I NA SI 38 Seiten. Motherboard - mini itx

Seite drucken
3.
IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for an Ultra DMA 100/66 signal cable. There are three
connectors on each Ultra DMA 100/66 signal cable: blue, black, and gray. Connect the
blue connector to the motherboard's IDE connector, then select one of the following
modes to configure your devices.
Single device
Two devices
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable
connector. This prevents incorrect insertion when you connect the IDE cable.
• If any device jumper is set as "Cable-Select", ensure that all other device jumpers have
the same setting.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
AT3GC-I IDE connector
1-9
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
PRI_IDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
Mode of device(s)
Cable connector
-
Master
Slave
Master
Slave
Chapter 1: Product introduction
Black
Black
Gray
Black or gray