Asus AT3GC-I NA SI Manual del usuario - Página 18

Navegue en línea o descargue pdf Manual del usuario para Placa base Asus AT3GC-I NA SI. Asus AT3GC-I NA SI 38 páginas. Motherboard - mini itx

IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for an Ultra DMA 100/66 signal cable. There are three

connectors on each Ultra DMA 100/66 signal cable: blue, black, and gray. Connect the

blue connector to the motherboard's IDE connector, then select one of the following

modes to configure your devices.

Single device

Two devices

Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable

connector. This prevents incorrect insertion when you connect the IDE cable.

• If any device jumper is set as "Cable-Select", ensure that all other device jumpers have

the same setting.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

AT3GC-I IDE connector

1-9

Drive jumper setting

Cable-Select or Master

Cable-Select

Master

Slave

PRI_IDE

NOTE:Orient the red markings

on the IDE ribbon cable to PIN 1.

Mode of device(s)

Cable connector

Master

Slave

Master

Slave

Chapter 1: Product introduction

Black

Gray

Black or gray