Dover Unified Brands Groen TDB-20 A TA/2 Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kommerzielle Lebensmittelausrüstung Dover Unified Brands Groen TDB-20 A TA/2 herunter. Dover Unified Brands Groen TDB-20 A TA/2 14 Seiten. Steam jacketed kettle
Seite drucken
WARNING
TURN OFF AGITATOR BEFORE ADDING
INGREDIENTS OR INSPECTING KETTLE
CONTENTS. DO NOT WEAR LOOSE CLOTHING
OR JEWELRY AROUND OPERATING MIXER
KETTLE. KEEP WELL CLEAR OF ROTATING
MIXER ARMS AND PADDLES AT ALL TIMES.
WARNING
THE UNIT IS EQUIPPED WITH AN
AUTOMATIC TILT CUTOFF SWITCH. IF
POWER IS ON WHEN A TILTED MIXER IS
LOWERED INTO OPERATING POSITION,
THE MIXER CAN AUTOMATICALLY START.
CAUTION
STARTING WITH THE MIXER SET AT HIGH
SPEED MAY CAUSE MATERIAL TO SPILL
OUT OF THE KETTLE ON VARIABLE
SPEED UNITS.
CAUTION
UNDER HEAVY LOAD DO NOT RUN THE
MIXER CONTINUOUSLY AT SLOWER
THAN 5% OF FULL SPEED. SLOWER
OPERATION COULD DAMAGE THE
SPEED CONTROL.
1. Before you operate the mixer, make sure that the agitator is firmly connected
with the drive shaft and properly positioned in the kettle. The agitator must be
positioned so every scraper blade touches the kettle during at least part of each
revolution. To connect the agitator:
Slip-on Coupling: Slide the coupling up onto the shaft as far as it will go. Then turn
the agitator and pull it down, so that the drive pin on the shaft becomes firmly
seated against the end of the J-slot.
2. If the mixer has been tilted up, lower it into operating position.
3. Turn on electric power to the unit at the circuit breaker or fuse box.
4. Switch on the drive.
5. Set the desired mixing speed. On a variable speed drive with electrical speed
control, turn the speed adjustment knob.
6. To stop the mixer, switch off the drive. Set the drive to low speed before switching
it off. If the cooker/mixer will be cleaned or serviced, or will not be used for a week
or longer, cut off all power supplies to the unit at the circuit breaker or fuse box.
7. Switch off the drive, before you tilt the mixer. To tilt the mixer, first unlatch it. For
some units, you may need to tilt the kettle forward slightly to let the agitator clear
the kettle wall as you tilt the mixer.
8. As you tilt the mixer out of the kettle, clean any clinging product from the agitator,
so product will not drip onto the outside of the kettle or surroundings, and so the
weight of product will not make the mixer fall down.
To operate the kettle component of your cooker/mixer, see the separate kettle manual.
Operation
OM-TDB-20/40, TA/2
7