Combi Rock N Roll Walker Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Baby-Zubehör Combi Rock N Roll Walker herunter. Combi Rock N Roll Walker 8 Seiten.

Assembly Instructions (continued)

5. Attach seat cover sides by inserting each

of the six (6) attachment tabs into the

slots on the side of the seat area (figure

5). Push tab into slot, then pull from the

bottom and flip tab to secure.

6. Place upper tray assembly upside down

on a flat surface.

7. Insert round end of each leg (4) into

round hole on underside of the upper

tray (figure 6).

8. Insert nut onto screw attachment by hand

to attach each leg.

9. Ensure that each leg is aligned with the

side of the upper tray, then use a coin to

tighten each attachment nut (figure 7).

10. Turn assembled parts upright.

11. Place base on a flat surface with smooth

side up.

12. Align the rear of the upper tray

assembly with the rear of the base.

IMPORTANT: The rear of the upper

tray must be aligned with the rear of

the base before attaching the two

pieces in the steps below. The rear

of the upper tray is where the seat

is located; the rear of the base has a

large round hole. (figure 8)

13. Loosely attach the upper tray

assembly to the base by inserting

the square ends of the legs into the

square holes on the sides of the

base, just over the tires. (figure 9)

back

figure 8

figure 5

figure 6

figure 7

front

figure 9

- 4 -