Combi Rock N Roll Walker 사용 설명서 - 페이지 4
{카테고리_이름} Combi Rock N Roll Walker에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Combi Rock N Roll Walker 8 페이지.
페이지 인쇄
Assembly Instructions (continued)
5. Attach seat cover sides by inserting each
of the six (6) attachment tabs into the
slots on the side of the seat area (figure
5). Push tab into slot, then pull from the
bottom and flip tab to secure.
6. Place upper tray assembly upside down
on a flat surface.
7. Insert round end of each leg (4) into
round hole on underside of the upper
tray (figure 6).
8. Insert nut onto screw attachment by hand
to attach each leg.
9. Ensure that each leg is aligned with the
side of the upper tray, then use a coin to
tighten each attachment nut (figure 7).
10. Turn assembled parts upright.
11. Place base on a flat surface with smooth
side up.
12. Align the rear of the upper tray
assembly with the rear of the base.
IMPORTANT: The rear of the upper
tray must be aligned with the rear of
the base before attaching the two
pieces in the steps below. The rear
of the upper tray is where the seat
is located; the rear of the base has a
large round hole. (figure 8)
13. Loosely attach the upper tray
assembly to the base by inserting
the square ends of the legs into the
square holes on the sides of the
base, just over the tires. (figure 9)
back
figure 8
figure 5
figure 6
figure 7
front
figure 9
- 4 -