AmpliVox AirVox S690 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Lautsprechersystem AmpliVox AirVox S690 herunter. AmpliVox AirVox S690 12 Seiten. Battery powered pa system with bluetooth

Seite drucken

16 CHANNEL UHF WIRELESS

WIRELESS RECEIVER PANEL

•

Channel Display (A)

•

RF - Radio Frequency Indicator (B)

•

AF - Audio Frequency Indicator (C)

•

ASC / IR Auto Channel Select (Handheld Microphone Only) (D)

•

Select Buttons - Manual Channel Selection (E)

•

Mute Level Adjustment (F)

•

Volume Control (G)

RECEIVER / TRANSMITTER SETUP:

•

Make sure that you have installed the UHF antenna.

•

The receiver has its own POWER / VOLUME Control (G). First make

sure that you have screwed on the UHF antenna. Turn Power On. A

Frequency Channel will appear in the Channel Display (A). Press Select

Buttons (E) to select a channel. Channel number MUST match channel

number on wireless transmitter.

•

The transmitter bodypack is operated by 1 - "AA" 1.5 Volt alkaline bat-

tery. Slide off battery cover (H) and install battery as shown. Make cer-

tain the battery is fully seated in its compartment so the cover slides in

place easily. Battery life with alkaline batteries is approximately 8 hours

of operating time.

•

Select a channel (1-16) on side panel (I) using the supplied screw driver

to select channel number. Channel selected MUST match channel on

receiver. When transmitter and receiver are set to correct channel the

RF indicator (B) will glow red when transmitter is turned on.

•

Plug the Lapel / Headset microphone into the Mic Input Jack (K). The

microphone can be clipped to your clothing, using the supplied clip. The

lapel mic should be placed under the chin, as close to the center of the

body as possible.

•

Slide the power ON/OFF switch (J) to the ON position (the LED indicator

light will illuminate green). Replace batteries when this LED turns red.

● MUTE LEVEL (F) is set at min level mark (counter clockwise) when it

leaves the factory for maximum range distance. If speaker sound is

breaking up (interference noise) when speaking, turn level clockwise with

small screwdriver until condition improves. Operating distance will be

affected.

•

GAIN SWITCH (L): If you are a soft spoken person then set the switch to

the 10 dB position. If you are a loud speaking person then set the switch

to the -10 dB position. Adjust to prevent distortion while speaking.

WIRELESS HANDHELD MICROPHONE - MODEL SW695 ONLY

If you are using the AmpliVox S1695 Wireless Handheld Microphone Transmitter, screw off the lower bottom section of microphone

and insert 2 - "AA" 1.5 Volt alkaline batteries.

IMPORTANT: Because the microphone has an AUTO SYNC function, you first select channel you wish to use on the receiver.

Then press the ASC button (D), the IR light will start to flash. Turn on microphone and point end N of microphone at the flashing

IR light on receiver and the microphone will auto sync to the same channel as selected on the receiver.

BATTERIES

1. Hold the body of microphone in hand and twist off bottom sec-

tion of microphone.

2. Insert two "AA" batteries.

3. Twist bottom section back on to microphone.

BATTERY STATUS

The life expectancy of the two batteries is about 10 hours. When the

"BATTERY" symbol on the display screen keeps flashing or light

level of screen gets very dim, the batteries should be replaced

immediately.

Wireless Transmitter - Bodypack - Model SW690 Only

Battery Cover

Channel Selector

Top Panel