Amprobe GROUND PROBE GP-1 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Prüfgeräte Amprobe GROUND PROBE GP-1 herunter. Amprobe GROUND PROBE GP-1 20 Seiten.

Memory Storage Control

METER/

FEET

SELECTOR

button

DISTANCE

SELECTOR

button

SAVE all test results, excluding voltage, can be saved into memory by pressing the

SAVE button. Each time the SAVE button is pressed, the next consecutive memory

location is displayed and the information is saved to that location.

The RECALL button works in conjunction with the function switch. When the RCL

button is pressed, "mem" and the last memory location will be displayed, followed

by the value, in that location for the test designated by the function switch.

Continuing to press the RCL button will allow the prior measurements and locations

to be displayed.

The CLEAR button has three functions:

1) To clear past memory location (before any other button was pressed or

function changed after saving). After the SAVE button has been pressed, press

the CLEAR button to clear the last memory location. After pressing the CLEAR

button, the cleared memory location will be displayed followed by clr.

2) To CLEAR all memory locations. With the function switch in Test A, B, C,

or D, press the CLEAR button to clear all memory locations. After the CLEAR

button is pressed, clr will flash and "mem" will be displayed. Press the CLEAR

button a second time to conclude memory clearing function. clr will be

displayed for approximately 5 seconds, followed by the three dashes.

3) To clear all memory locations and reset two point calibration. With unit

OFF, press and hold the CLEAR button, then turn the unit ON. ES will be

displayed followed by the three dashes. All memory locations will be cleared.

If a two point (Test B) is to be performed, the unit must be calibrated (nulled)

prior to the test.

To verify that all memory locations have been cleared, switch the function

switch to Test A, then press the RCL button. no mem will be displayed followed

by three dashes. Repeat for Test B, C and D.

CLEAR

button

SAVE

button

View of Control Panel

RECALL

button

Page 5