AMS AS5600 Betriebshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Kontrolleinheit AMS AS5600 herunter. AMS AS5600 12 Seiten. 12-bit programmable contactless potentiometer
Auch für AMS AS5600: Handbuch (14 seiten), Benutzerhandbuch (13 seiten), Betriebshandbuch (10 seiten)

Seite drucken
AMS AS5600 Betriebshandbuch
AS5600-SO_RD_ST
Operation Manual
1

General Description

The reference design allows an easy and fast evaluation of the AS5600 rotary magnetic position
sensor in the lab. Additionally it is possible to replace an existing potentiometer with the AS5600-
SO_RD_ST. The module is fully assembled with and pcb including the AS5600 position sensor and
its necessary external components. All relevant signals are available on a 7-way connector and can
be easily wired to an existing application. Additionally there are tree-pin header to replace existing
potentiometers.
The AS5600 is a programmable Hall-based rotary magnetic position sensor with a high-resolution
12-bit analog or PWM output for contactless potentiometers. Based on planar Hall technology, this
device measures the orthogonal component of the flux density (Bz) from an external magnet while
rejecting stray magnetic fields.
The default range of the output is 0 to 360 degrees, but the full resolution of the device can be
applied to smaller range by programming a zero angle (start position) and maximum angle (stop
position).
The I²C interface is used for configuration and user programming of non-volatile parameters in the
AS5600 without requiring a dedicated programmer.

1.1 Kit Content

This kit contains following material listed in
webpage.
Table 1:
Kit Content
No.
Item
1
AS5600-SO_RD_ST
2
Quick Start Guide
2

Getting Started

The AS5600 reference design is a contactless potentiometer. It can be programmed in 3-Wire Mode
or over I
2
C.

2.1 Adapter Board Pin-Out

The pin-out of the reference module pcb is shown in
Table
2. For additional information on the AS5600 pins refer to the product datasheet.
www.ams.com
Table
1. Additional material can be found on our
Description
Revision 1.1 / 30.06.2014
Info
Reference Module including PCB
page 3/11