AMSEC 5BE Betriebsanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Schlösser AMSEC 5BE herunter. AMSEC 5BE 4 Seiten. 5-button electronic lock

Seite drucken

AMSEC 5-Button Electronic Lock Model 5BE Operating Instructions

Quick Reference

To Open the Lock on the factory code:

Press 1-2-3-4-5 and then turn knob clockwise about 90 degrees.

To Set the Primary Code:

Lock the safe OPEN. Press the change button once; then enter

5 keystrokes for the new primary code. Test the new code.

To Set the Backup Code:

Lock the safe OPEN. Press the change button twice; then enter

8 keystrokes for the new backup code. Test the new code.

To Set the Features:

Press the change button three times.

One Beep = On, Two Beeps = Off

Button 1 = LED Lamp.

Button 2 = Beeper.

Button 3 = Duress Signal.

Wait until the red LED shuts off.

To Send a Duress (Silent) Signal:

Enter your code (primary or backup), then press keys 1 and 5

simultaneously within three (3) seconds of your final key-

stroke, then turn the knob to open.

Revised February, 2005

Programming

The 5BE lock is programmable, so the user can change codes and con-

trol features.

To Set the Primary Code:

1. Lock the safe OPEN.

2. Press the change button once.

3. Enter five (5) keystrokes for the new primary code.

4. Test the new code.

To Set the Backup Code:

Lock the safe OPEN.

Press the change button twice.

Enter eight (8) keystrokes for the new backup code.

Test the new code.

To Set the Features:

Press the change button three times to activate the feature

programming mode.

The features are "assigned" to individual buttons on the key-

pad when you are in the feature programming mode.

A feature is turned ON by pressing the button for that fea-

ture and the unit sounds one (1) beep.

A feature is turned OFF by pressing the button for that fea-

ture and the unit sounds two (2) beeps.

Repeated pressing of a feature button will toggle the feature

ON/OFF

Button Assignments are:

1. Button 1 = LED Lamp.

2. Button 2 = Beeper.

3. Button 3 = Duress Signal.

When finished with programming, stop pressing buttons and wait

10 seconds for the red LED lamp on the keypad to shut off.