Draper PT680V Anleitung Handbuch - Seite 7
Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Elektrowerkzeug Draper PT680V herunter. Draper PT680V 12 Seiten. 600w orbital jigsaw
Seite drucken
OPERATION AND USE
IMPORTANT:
✫✌
Fig.2
Make sure that the mains voltage matches the
voltage stated on the machines rating plate.
THE SWITCH WITH HOLDING BUTTON:
The machine is set to operation by pressing
the handle switch ✪✌ (Fig.2). To use continuously
✬✌
squeeze trigger ✪✌, press button ✫✌ and hold in.
Release trigger ✪✌. Release button ✫✌, the machine
will continue to run. To stop the machine squeeze
trigger ✪✌, button ✫✌ will automatically release.
✪✌
SPEED REGULATION:
Depending on the application the rotation speed can
be varied by turning the knurled button ✬✌, (Fig2.).
NOTE: The rotation speed is dependent upon the
pressure applied during working. Do not over
Fig.3
load the machine.
IMPORTANT: Given the special shape of the body,
these machines can be operated with only one hand,
but for reasons of safety it is strongly advised to
keep both hands on the machine during use.
INTERNAL CUTS
A hole must be drilled in the material, in order to
provide a starting point for the saw blade.
Alternatively the saw blade can be directly inserted
into the material (only for wood work pieces). This
operation should only be performed by operators
with considerable work experience and with
short blades only.
With the machine running at full speed the saw
blade should be rested on the work piece at an
55º- 60º
angle of 55º-60º (Fig.3) in relation to the front edge of
the base, it should then be pressed, slowly and
carefully, onto the material.
The first phase of the operation should be
undertaken with great care: sudden counter-strokes
and overloads during contact between the blade and
work piece, or excessively rapid penetration of the
material, can provoke blade breakage.
This method of starting an internal cut should only
be carried out at maximum speed and maximum
orbital action.
- 6 -