Draper PT680V 사용 설명서 - 페이지 7

{카테고리_이름} Draper PT680V에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper PT680V 12 페이지. 600w orbital jigsaw

페이지 인쇄

OPERATION AND USE

IMPORTANT:

✫✌

Fig.2

Make sure that the mains voltage matches the

voltage stated on the machines rating plate.

THE SWITCH WITH HOLDING BUTTON:

The machine is set to operation by pressing

the handle switch ✪✌ (Fig.2). To use continuously

✬✌

squeeze trigger ✪✌, press button ✫✌ and hold in.

Release trigger ✪✌. Release button ✫✌, the machine

will continue to run. To stop the machine squeeze

trigger ✪✌, button ✫✌ will automatically release.

✪✌

SPEED REGULATION:

Depending on the application the rotation speed can

be varied by turning the knurled button ✬✌, (Fig2.).

NOTE: The rotation speed is dependent upon the

pressure applied during working. Do not over

Fig.3

load the machine.

IMPORTANT: Given the special shape of the body,

these machines can be operated with only one hand,

but for reasons of safety it is strongly advised to

keep both hands on the machine during use.

INTERNAL CUTS

A hole must be drilled in the material, in order to

provide a starting point for the saw blade.

Alternatively the saw blade can be directly inserted

into the material (only for wood work pieces). This

operation should only be performed by operators

with considerable work experience and with

short blades only.

With the machine running at full speed the saw

blade should be rested on the work piece at an

55º- 60º

angle of 55º-60º (Fig.3) in relation to the front edge of

the base, it should then be pressed, slowly and

carefully, onto the material.

The first phase of the operation should be

undertaken with great care: sudden counter-strokes

and overloads during contact between the blade and

work piece, or excessively rapid penetration of the

material, can provoke blade breakage.

This method of starting an internal cut should only

be carried out at maximum speed and maximum

orbital action.

- 6 -