Draper 65839 Anleitung Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Säge Draper 65839 herunter. Draper 65839 20 Seiten. 10"

Seite drucken

ONLY WITH THE POWER SWITCHED OFF

AND THE MACHINE UNPLUGGED SHOULD

ANY ADJUSTMENTS, MAINTENANCE OR

REPAIRS BE CARRIED OUT.

RIP FENCE (FIGS. 4 & 5):

CAUTION:

THE RIP FENCE MUST BE ALIGNED

PARALLEL TO THE BLADE TO MINIMIZE THE

DANGER OF KICK BACK.

Place the rip fence on the side of the table, most

comfortable for your hand orientation. For

example, if you are left handed, the fence would

be secured to the right of the blade.

With the blade guard lifted out of the way, set the

blade to the full height (see page 9) lift the

kickback pawl up to allow the fence to be pushed

flush to the blade. Lock the rear knob ✭✌ and

front locking handle ✮✌ so the fence is securely

held tight against the table. If the fence is not fully

secure, remove the fence and at the rear on

✮✌, under the fence is an adjustment

handle

screw which when moved will allow more grip

with the front handle. On the front fence assembly,

ensure the marker guide is set to zero. If

adjustment is required, loosen screw ✯✌, slide the

plate so zero is correct and then retighten screw

✯✌. Now the fence can be slid to the desired

width of cut and locked in place. To check the

accuracy of the guide, use a metal rule from the

fence and measure the gap between the front of

the blade and also at the back. The measurement

is from the cutting side of the tooth ✰✌. This

measurement should be checked regularly and if

necessary adjusted. When making critical cuts,

always make a test cut from a piece of scrap

timber.

MITRE GAUGE (FIG.6):

The mitre gauge is a guide. The gauge slides

along the two grooves ✱✌ in the table. It should

be checked against the blade using an engineers

square (Draper Stock No.34065) to ensure greater

accuracy. Loosen locking knob ✲✌ and using the

square, set the gauge at 90º to the blade. Now lock

knob ✲✌. Push in rod ✳✌ and adjust quick stop

✴✌ so the set screw touches rod ✳✌, and lock in

place. Carry out the same procedure for the two

45º stops using a protractor (Draper Stock

No.52430) against the blade.

NOTE:

The quick stop is designed to allow quick setting

of the 90º and 45º angles on the gauge. To set

other angles, pull rod ✳✌ out and set manually.

Ensure the locking knob ✲✌ is secured before any

cutting takes place.

ASSEMBLY

✭✌

✯✌

- 8 -

✮✌

✰✌

✲✌

✴✌

✳✌

Fig.4.

Fig.5.

Fig.6.

✱✌