Draper Clutch Operated FlexShade Anweisungen für Installation und Betrieb - Seite 4

Blättern Sie online oder laden Sie pdf Anweisungen für Installation und Betrieb für Inneneinrichtung Draper Clutch Operated FlexShade herunter. Draper Clutch Operated FlexShade 7 Seiten.

Seite drucken
Clutch Operated FlexShade
Window shade with smooth, quiet operation, and independent control
Section 2 - Bead Chain Clutch Installation
Section 2.1 - 20# Clutches
1. Mark wall, jamb or ceiling for placement of mounting endcaps and drill small starter hole
in mounting surface.
2. Place spring-loaded pin into idler endcap, slip notches on clutch into clutch endcap.
(Fig.
Press down to lock in place
3. Route bead chain through chain guide, then attach cover using provided screw.
4. If installing Fascia,
(see Section 4.1 - Attaching Fascia to
Endcaps - 20# Clutch Installation
Idler
Endcap
Retainer Clip
Section 2.1 - 24# Clutches
1. Mark wall, jamb or ceiling for placement of mounting endcaps and drill small starter hole in surface.
2. Install clutch onto spear on operator endcap. Slide notched pin into idler endcap. Replace retainer clip
3. Route bead chain through chain guide, then attach cover using provided screw.
4. If installing Fascia,
(see Section 4.1 - Attaching Fascia to
Caution: Be sure retainer clip installed on roller with 24 lb clutch.
DO NOT use 24 lb. clutch wall brackets on ceiling installations.
DO NOT use 24 lb. clutch ceiling brackets for wall installations.
24 lb. Clutches are LEFT and RIGHT specific.
Endcaps - 24# Clutch Installation
Idler
Idler
Endcap
Endcap
Retainer Clip
(Endcaps)
5).
Endcaps). If not, snap on Endcap Covers.
Idler End
of Roller
(see Fig. 6)
Endcaps). If not, snap on Endcap Covers.
Idler End
of Roller
®
(if necessary)
10 lb Clutch
Large
4½" x 4½"
(114 x 114mm)
11
/
"
16
(17mm)
2 ¾"
(70mm)
24 lb Clutch
45°
page 4 of 7
Small
2"
(51mm)
3¾" x 3¼"
(96 x 83mm)
3 ¼"
(83mm)
2 ¼"
3 ¾"
(57mm)
(96mm)
Figure 5
Clutch
Endcap
3 ¼"
(83mm)
4 ½"
(114mm)
4 ½"
(114mm)
Figure 6
Clutch
Endcap
11
/
"
16
(17mm)