Draper Clutch Operated FlexShade Anweisungen für Installation und Betrieb - Seite 7

Blättern Sie online oder laden Sie pdf Anweisungen für Installation und Betrieb für Inneneinrichtung Draper Clutch Operated FlexShade herunter. Draper Clutch Operated FlexShade 7 Seiten.

Seite drucken

Clutch Operated FlexShade

Window shade with smooth, quiet operation, and independent control

Section 5 - Bead Chain Limits and Saftey Device Installation

Section 5.1 - Attaching Stop Balls

1. Set upper and lower travel limits by installing stop balls to bead chain

Section 5.2 - P-Clip Cord Tension Device

Please Note: Draper Bead Chain Clutch Operated shades that do not comply with WMCA/ANSI Standard

A100.1-2018 come with a P-Clip cord tension device pre-attached to bead chain

must be attached to wall, jamb or sill so that bead chain is held taut enough that children cannot pull it

away from wall or fit their head into loop.

Section 5.3 - Spring-Loaded Cord Tension Device

For Draper Clutch FlexShades that comply with WMCA/ANSI Standard A100.1-2012, a Spring-Loaded Cord Tension Device comes installed on bead chain

(Fig.

13). An approved permanent warning label is attached, and approved mechanical fasteners

to wall, jamb or sill. To install, pull tensioner down and use mounting hardware to keep bead chain taut enough to move smoothly through device. Without

sufficient tension, device will not allow bead chain to operate shade. This device is designed so that children cannot pull bead chain away from wall or fit

(Safety notes, page

their head into loop

Please Note: Overtightening screws will damage the Spring Loaded Tension Device.

(Safety notes, page 2)

2). For more information, visit

Sill

Mount

Figure 13

(crimp closed using pliers) (Fig.

(Fig.

12). This device

(wood screws)

www.draperinc.com/WindowShades/WCMAcompliance.asp.

Jamb

Mount

Tensioner

11).

Attach

Stop Balls

are included. Install cord tension device

page 7 of 7

Crimp

Closed

with

Pliers

Figure 11

Figure 12