Draper Clutch Operated FlexShade Istruzioni per l'installazione e il funzionamento - Pagina 7
Sfoglia online o scarica il pdf Istruzioni per l'installazione e il funzionamento per Arredamento per interni Draper Clutch Operated FlexShade. Draper Clutch Operated FlexShade 7.
Stampa la paginaClutch Operated FlexShade
Window shade with smooth, quiet operation, and independent control
Section 5 - Bead Chain Limits and Saftey Device Installation
Section 5.1 - Attaching Stop Balls
1. Set upper and lower travel limits by installing stop balls to bead chain
Section 5.2 - P-Clip Cord Tension Device
Please Note: Draper Bead Chain Clutch Operated shades that do not comply with WMCA/ANSI Standard
A100.1-2018 come with a P-Clip cord tension device pre-attached to bead chain
must be attached to wall, jamb or sill so that bead chain is held taut enough that children cannot pull it
away from wall or fit their head into loop.
Section 5.3 - Spring-Loaded Cord Tension Device
For Draper Clutch FlexShades that comply with WMCA/ANSI Standard A100.1-2012, a Spring-Loaded Cord Tension Device comes installed on bead chain
(Fig.
13). An approved permanent warning label is attached, and approved mechanical fasteners
to wall, jamb or sill. To install, pull tensioner down and use mounting hardware to keep bead chain taut enough to move smoothly through device. Without
sufficient tension, device will not allow bead chain to operate shade. This device is designed so that children cannot pull bead chain away from wall or fit
(Safety notes, page
their head into loop
Please Note: Overtightening screws will damage the Spring Loaded Tension Device.
(Safety notes, page 2)
2). For more information, visit
Sill
Mount
Figure 13
®
(crimp closed using pliers) (Fig.
(Fig.
12). This device
(wood screws)
www.draperinc.com/WindowShades/WCMAcompliance.asp.
Jamb
Mount
Tensioner
11).
Attach
Stop Balls
are included. Install cord tension device
page 7 of 7
Crimp
Closed
with
Pliers
Figure 11
Figure 12