Draper Exterior Motorized FlexShade XL Anweisungen für Installation und Betrieb - Seite 3

Blättern Sie online oder laden Sie pdf Anweisungen für Installation und Betrieb für Inneneinrichtung Draper Exterior Motorized FlexShade XL herunter. Draper Exterior Motorized FlexShade XL 10 Seiten.

Seite drucken
Exterior Motorized FlexShade

Section 1 - Preparation for Installation

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
MOUNTING
1 "
BRACKET
(44 mm)
E N
D C
A P
Figure 1

Section 2 - Mounting Headbox with Cassette Brackets

Section 2.1 - Wall Installation
Caution: Mounting brackets
required for proper spacing of unit
off the wall for side channel
alignment.
1
Figure 3-A
Section 2.2 - Ceiling Installation
1. Attach mounting brackets to ceiling using #10 flat
head screws installed flush with bracket. USE ALL
FOUR
mounting holes
(4)
(Fig. 3-B)
1
Figure 3-B
1. Ensure mounting surface is strong enough to hold the Exterior Motorized FlexShade
2. Verify unit measurements and make sure it will fit in the desired location.
Please Note: Hem Bar does not retract into
the Headbox and must be accounted for if
mounting over a swinging window or door.
3. Mounting brackets MUST be installed with a
gap of 1 3/4"
between the Endcap and
(44mm)
the Mounting Bracket edge
jamb, or ceiling.
4. Drill small starter holes
(if necessary)
mounting surface.
5. Determine which headbox style is being
used
.
(Fig. 2)
1. Attach mounting brackets to the wall using #10 flat
head screws installed flush with bracket.
Please Note: Be sure to use AT LEAST 2 of the top
mounting holes
(Fig. 3-A)
2
2. Attach Headbox to brackets and tighten Set Screws
3. Install Cable Guides
.
2
XL
®
. Mark wall,
(Fig. 1)
in
5"
Headbox
(127mm)
.
3
.
(Section 3)
3
page 3 of 10
XL.
®
Figure 2
HEADBOX STYLES
5"
(127mm)
Angled
5"
Headbox
(127mm)
2. Attach Headbox to brackets and tighten
Set Screws
.
(Fig. 3-A)
3. Install Cable Guides
(Section 3)
4
Tighten Set Screws
.
(Fig. 3-B)
4
Tighten Set Screws
5"
(127mm)
Curved
.