Draper Exterior Motorized FlexShade XL Installation & Operation Instructions - Page 3

Browse online or download pdf Installation & Operation Instructions for Indoor Furnishing Draper Exterior Motorized FlexShade XL. Draper Exterior Motorized FlexShade XL 10 pages.

Print Page
Exterior Motorized FlexShade

Section 1 - Preparation for Installation

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
MOUNTING
1 "
BRACKET
(44 mm)
E N
D C
A P
Figure 1

Section 2 - Mounting Headbox with Cassette Brackets

Section 2.1 - Wall Installation
Caution: Mounting brackets
required for proper spacing of unit
off the wall for side channel
alignment.
1
Figure 3-A
Section 2.2 - Ceiling Installation
1. Attach mounting brackets to ceiling using #10 flat
head screws installed flush with bracket. USE ALL
FOUR
mounting holes
(4)
(Fig. 3-B)
1
Figure 3-B
1. Ensure mounting surface is strong enough to hold the Exterior Motorized FlexShade
2. Verify unit measurements and make sure it will fit in the desired location.
Please Note: Hem Bar does not retract into
the Headbox and must be accounted for if
mounting over a swinging window or door.
3. Mounting brackets MUST be installed with a
gap of 1 3/4"
between the Endcap and
(44mm)
the Mounting Bracket edge
jamb, or ceiling.
4. Drill small starter holes
(if necessary)
mounting surface.
5. Determine which headbox style is being
used
.
(Fig. 2)
1. Attach mounting brackets to the wall using #10 flat
head screws installed flush with bracket.
Please Note: Be sure to use AT LEAST 2 of the top
mounting holes
(Fig. 3-A)
2
2. Attach Headbox to brackets and tighten Set Screws
3. Install Cable Guides
.
2
XL
®
. Mark wall,
(Fig. 1)
in
5"
Headbox
(127mm)
.
3
.
(Section 3)
3
page 3 of 10
XL.
®
Figure 2
HEADBOX STYLES
5"
(127mm)
Angled
5"
Headbox
(127mm)
2. Attach Headbox to brackets and tighten
Set Screws
.
(Fig. 3-A)
3. Install Cable Guides
(Section 3)
4
Tighten Set Screws
.
(Fig. 3-B)
4
Tighten Set Screws
5"
(127mm)
Curved
.