Draper FlexShade Anleitung Installation & Betrieb - Seite 8

Blättern Sie online oder laden Sie pdf Anleitung Installation & Betrieb für Inneneinrichtung Draper FlexShade herunter. Draper FlexShade 12 Seiten. Exterior clutch-operated shade
Auch für Draper FlexShade: Handbuch für Installation und Betrieb (8 seiten), Einbauanleitung (2 seiten), Anleitung Handbuch (12 seiten), Anweisungen für Installation und Betrieb (11 seiten), Anleitung Installation & Betrieb (16 seiten), Anleitung Installation & Betrieb (4 seiten), Anleitung Handbuch (7 seiten), Anleitung Installation & Betrieb (12 seiten), Anleitung Installation & Betrieb (16 seiten)

Seite drucken
Draper FlexShade Anleitung Installation & Betrieb
Dual Roller Coupled Motorized FlexShade

Section 6 - Fabric/Roller Assembly Alignment

Please note: If needed, the fabric panel heights can be adjusted so that the bottom edges of the fabric panels are aligned. On large units, this procedure should be
done on only one panel at a time to minimize the amount of fabric weight that must be supported during the adjustment procedure. Install and adjust rear/upper
panls before beginning on lower/front panels.
1.
Unlock height adjuster mechanism
located at the operator-end of fabric roller assembly being
adjusted by rotating the metal ring
approximately ¼ turn
counterclockwise when
viewing the face of the
coupler
assembly.
LOCK
LOCK
LOCK
LOCK
3.
Rotate the fabric/roller
assembly in either
direction to raise or lower
the fabric panel.
LOCK
LOCK
UNLOCK
UNLOCK
7.
Install
next panel.
(or coupler shaft receiver)
UNLOCK
UNLOCK
UNLOCK
UNLOCK
Please note: Do not use this procedure
to adjust the operator-end assembly.
Use the limits to set the down travel of
the operator-end assembly.
4.
Allow the fabric/
roller assembly
to move back
and away from the operator
end of the unit, and check
position of fabric panels.
Location of next panel
®
(Extra Large Hardware)
(Steps are shown for right-hand operators)
2.
Push the fabric/roller assembly approximately 3/16"
toward the operator-end of the unit. The fabric/roller
assembly will move approximately
3/16"
toward the
(8 mm)
operator end.
5.
Tighten the locking ring by firmly rotating it approximately
¼ turn clockwise
6.
Operate the unit
to check for proper
fabric position,
tracking, etc.
Caution: Ensure the locking ring on the idler-end coupler assembly is
fully tightened following height adjustment. Wear a heavy glove to grip
the locking ring. Tighten the locking ring until it is fully locked and will
not rotate any further. Ensure that it will not loosen. If it cannot be
tightened by hand, use a flat screwdriver or other tool to assist.
page 8 of 12
.
(reverse of step 1)
LOCK
LOCK
UNLOCK
UNLOCK
Operator Panel
(5mm)