Draper FlexShade Installatie- en bedieningsinstructies - Pagina 8

Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} Draper FlexShade. Draper FlexShade 12 pagina's. Exterior clutch-operated shade
Ook voor Draper FlexShade: Installatie- en bedieningshandleiding (8 pagina's), Installatie-instructies (2 pagina's), Gebruiksaanwijzing (12 pagina's), Installatie- en bedieningsinstructies (11 pagina's), Installatie- en bedieningsinstructies (16 pagina's), Installatie- en bedieningsinstructies (4 pagina's), Gebruiksaanwijzing (7 pagina's), Installatie- en bedieningsinstructies (12 pagina's), Installatie- en bedieningsinstructies (16 pagina's)

Pagina afdrukken

Draper FlexShade Installatie- en bedieningsinstructies

Dual Roller Coupled Motorized FlexShade

Section 6 - Fabric/Roller Assembly Alignment

Please note: If needed, the fabric panel heights can be adjusted so that the bottom edges of the fabric panels are aligned. On large units, this procedure should be

done on only one panel at a time to minimize the amount of fabric weight that must be supported during the adjustment procedure. Install and adjust rear/upper

panls before beginning on lower/front panels.

Unlock height adjuster mechanism

located at the operator-end of fabric roller assembly being

adjusted by rotating the metal ring

approximately ¼ turn

counterclockwise when

viewing the face of the

coupler

assembly.

LOCK

Rotate the fabric/roller

assembly in either

direction to raise or lower

the fabric panel.

LOCK

UNLOCK

Install

next panel.

(or coupler shaft receiver)

UNLOCK

Please note: Do not use this procedure

to adjust the operator-end assembly.

Use the limits to set the down travel of

the operator-end assembly.

Allow the fabric/

roller assembly

to move back

and away from the operator

end of the unit, and check

position of fabric panels.

Location of next panel

(Extra Large Hardware)

(Steps are shown for right-hand operators)

Push the fabric/roller assembly approximately 3/16"

toward the operator-end of the unit. The fabric/roller

assembly will move approximately

3/16"

toward the

(8 mm)

operator end.

Tighten the locking ring by firmly rotating it approximately

¼ turn clockwise

Operate the unit

to check for proper

fabric position,

tracking, etc.

Caution: Ensure the locking ring on the idler-end coupler assembly is

fully tightened following height adjustment. Wear a heavy glove to grip

the locking ring. Tighten the locking ring until it is fully locked and will

not rotate any further. Ensure that it will not loosen. If it cannot be

tightened by hand, use a flat screwdriver or other tool to assist.

page 8 of 12

(reverse of step 1)

LOCK

UNLOCK

Operator Panel

(5mm)