Draper FlexShade Anleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Inneneinrichtung Draper FlexShade herunter. Draper FlexShade 7 Seiten. Exterior clutch-operated shade
Auch für Draper FlexShade: Handbuch für Installation und Betrieb (8 seiten), Einbauanleitung (2 seiten), Anleitung Handbuch (12 seiten), Anweisungen für Installation und Betrieb (11 seiten), Anleitung Installation & Betrieb (12 seiten), Anleitung Installation & Betrieb (16 seiten), Anleitung Installation & Betrieb (4 seiten), Anleitung Installation & Betrieb (12 seiten), Anleitung Installation & Betrieb (16 seiten)

Seite drucken

Dual Roller 12V Battery FlexShade

Section 1 - Mounting Endcaps

Please Note: Installer is responsible for selecting

mounting hardware appropriate for site conditions.

1. Snap endcap covers onto endcaps. The proper

orientation of Left-Hand, Right-Hand, Front

and Back is molded into endcap covers

2. Mark wall, jamb, or ceiling for placement of

mounting endcaps.

3. Drill small starter hole

(if necessary)

mounting surface.

4. Mount endcaps using appropriate fasteners

for surface.

For ST30 Motors

1. Place rear shade spring-loaded pin in idler

endcap.

2. Depress spring-loaded pin by pressing the

shade roller toward the endcap.

3. Slip operator end of rear shade into slots on

operator end endcap

(Fig. 2)

4. Repeat with front shade.

Section 2 - Installing Fascia

1. Place groove along top of fascia over end caps, and

. Fascia is not fully seated until

snap into place

(Fig. 4)

it clicks into place on both ends.

2. Once in place, check for secure fit. If not secure,

secure with appropriate fastener

PLEASE NOTE: Refer to appropriate

sections within this document

for different installation options:

SECTION 3:

Surface Headbox Installation

SECTION 4:

Pocket Headbox Installation

(Brackets)

ENDCAP

COVER

A N

- H

F T

L E

(Fig. 1)

Figure 2

For Battery-Powered Motors

1. Mount Battery Wands to wall using provided Mounting Clips

where they can reach the motor without interfering with shade/roller operation.

Please Note: If mounting the battery wands vertically, small plastic grips are provided to slide onto

the battery pack and create a snugger fit in the bracket.

2. Place rear shade spring-loaded

pin in idler endcap, depress

spring-loaded pin by pressing

the shade roller toward

the endcap and slip the

operator end of rear shade

into slots on operator

endcap

3. Connect battery packs

together, and to motor.

4. Repeat with front shade.

(not included)

24V AND BATTERY

OPERATOR ENDCAPS

S N A

T O

P - O

(Fig. 2)

STEP 1

O N

A P -

S N

Figure 1

. Locate the battery wands

(Fig. 3)

Figure 3

STEP 2

Figure 4

Clicks into place

page 3 of 7

ENDCAP

COVER

R I

G H

T - H

A N

D T

O P

O N

A P -

S N

To Motor