Dual Roller 12V Battery FlexShade
Section 1 - Mounting Endcaps
Please Note: Installer is responsible for selecting
mounting hardware appropriate for site conditions.
1. Snap endcap covers onto endcaps. The proper
orientation of Left-Hand, Right-Hand, Front
and Back is molded into endcap covers
2. Mark wall, jamb, or ceiling for placement of
mounting endcaps.
3. Drill small starter hole
(if necessary)
mounting surface.
4. Mount endcaps using appropriate fasteners
for surface.
For ST30 Motors
1. Place rear shade spring-loaded pin in idler
endcap.
2. Depress spring-loaded pin by pressing the
shade roller toward the endcap.
3. Slip operator end of rear shade into slots on
operator end endcap
(Fig. 2)
4. Repeat with front shade.
Section 2 - Installing Fascia
1. Place groove along top of fascia over end caps, and
. Fascia is not fully seated until
snap into place
(Fig. 4)
it clicks into place on both ends.
2. Once in place, check for secure fit. If not secure,
secure with appropriate fastener
PLEASE NOTE: Refer to appropriate
sections within this document
for different installation options:
SECTION 3:
Surface Headbox Installation
SECTION 4:
Pocket Headbox Installation
(Brackets)
ENDCAP
COVER
A N
- H
F T
.
L E
(Fig. 1)
in
Figure 2
For Battery-Powered Motors
1. Mount Battery Wands to wall using provided Mounting Clips
where they can reach the motor without interfering with shade/roller operation.
Please Note: If mounting the battery wands vertically, small plastic grips are provided to slide onto
the battery pack and create a snugger fit in the bracket.
2. Place rear shade spring-loaded
pin in idler endcap, depress
spring-loaded pin by pressing
the shade roller toward
the endcap and slip the
operator end of rear shade
into slots on operator
endcap
3. Connect battery packs
together, and to motor.
4. Repeat with front shade.
.
.
(not included)
®
24V AND BATTERY
OPERATOR ENDCAPS
S N A
P
T O
D
P - O
N
.
(Fig. 2)
STEP 1
O N
A P -
S N
Figure 1
. Locate the battery wands
(Fig. 3)
Figure 3
STEP 2
Figure 4
Clicks into place
page 3 of 7
ENDCAP
COVER
R I
G H
T - H
A N
D T
O P
O N
A P -
S N
To Motor
페이지 인쇄