Electrolux EW 622 K Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Waschmaschine Electrolux EW 622 K herunter. Electrolux EW 622 K 14 Seiten.

Seite drucken

INSTALLATION

Unpacking

The parts protecting the inner components of the

machine during transit are red. They must all be removed

before using your machine for the first time. These

parts and their securing means should be kept in case

the machine has to be transported again.

Fig.1

1. Unpack the appliance. Open the lid of the appliance and

remove the polystyrene wedge which blocks the drum.

Close the lid (fig.1).

2. Tip the appliance backwards. Remove the two screws (A)

with red washers on the base of the washing machine with

the special spanner provided (fig.2).

Fig.3

3. Remove the loosened spacers (C). Stand the appliance

upright again (fig.3).

4. On the back part and with the special spanner, remove

the two red loosened spacers (D) (fig.4).

Fig.5

5. The holes which are now visible must be closed with the

plugs (F) provided with the appliance.

6. Please ensure that these parts have been removed from

the machine and keep them in case of next transport (fig.6).

Be careful : when the machine is installed on carpeted floor,

ensure that the carpet do not obstruct the openings, located

at the base of the machine, which are provided for ventila-

tion.

Fig.2

Fig.4

Fig.6

If you want to keep the alignment of

your appliance with the adjacent

cupboards, you have the possibility

to cut the crossbar holding the hoses

located at the back of your washing

machine (fig.6).

Water connection

Water inlet hose :

is advisable to run off a certain amount of water before

connecting the machine. This will avoid foreign matter

blocking the filter placed at the end of the water inlet hose.

Water outlet hose :

Place the curved end of the outlet hose into a drain pipe

having a height between 60 and 80 cm from floor level or

secure it to a sink or bath tub. Make sure that the drain hose

is firmly secured so that it will not slip out or fall down from

its position.

The water should drain freely and, consequently, the drain

hose should not be choked or placed in such a way as to

obstruct the normal water flow. If an extension hose is

required, remember that it might cause a malfunction in the

drain pump, particularly if the extension has a length in

excess of 1 meter or if the diameter of the extension is

smaller than the diameter of the original drain hose.

Connect the water inlet hose to

a cold water tap with a 3/4" gas

threaded orifice, after having

inserted the rugger sealing

washer with incorporated filter

(supplied with the machine) into

the hose collar. If the water

connection is made onto new

pipes or onto pipes which have

not been used for a long time, it