Electrolux EW 622 K Instruction Manual - Page 4
Browse online or download pdf Instruction Manual for Washer Electrolux EW 622 K. Electrolux EW 622 K 14 pages.
INSTALLATION
Unpacking
The parts protecting the inner components of the
machine during transit are red. They must all be removed
before using your machine for the first time. These
parts and their securing means should be kept in case
the machine has to be transported again.
Fig.1
1. Unpack the appliance. Open the lid of the appliance and
remove the polystyrene wedge which blocks the drum.
Close the lid (fig.1).
2. Tip the appliance backwards. Remove the two screws (A)
with red washers on the base of the washing machine with
the special spanner provided (fig.2).
Fig.3
C
3. Remove the loosened spacers (C). Stand the appliance
upright again (fig.3).
4. On the back part and with the special spanner, remove
the two red loosened spacers (D) (fig.4).
F
Fig.5
5. The holes which are now visible must be closed with the
plugs (F) provided with the appliance.
6. Please ensure that these parts have been removed from
the machine and keep them in case of next transport (fig.6).
Be careful : when the machine is installed on carpeted floor,
ensure that the carpet do not obstruct the openings, located
at the base of the machine, which are provided for ventila-
tion.
Fig.2
A
Fig.4
D
Fig.6
If you want to keep the alignment of
your appliance with the adjacent
cupboards, you have the possibility
to cut the crossbar holding the hoses
located at the back of your washing
machine (fig.6).
Water connection
Water inlet hose :
is advisable to run off a certain amount of water before
connecting the machine. This will avoid foreign matter
blocking the filter placed at the end of the water inlet hose.
Water outlet hose :
Place the curved end of the outlet hose into a drain pipe
having a height between 60 and 80 cm from floor level or
secure it to a sink or bath tub. Make sure that the drain hose
is firmly secured so that it will not slip out or fall down from
its position.
The water should drain freely and, consequently, the drain
hose should not be choked or placed in such a way as to
obstruct the normal water flow. If an extension hose is
required, remember that it might cause a malfunction in the
drain pump, particularly if the extension has a length in
excess of 1 meter or if the diameter of the extension is
smaller than the diameter of the original drain hose.
Connect the water inlet hose to
a cold water tap with a 3/4" gas
threaded orifice, after having
inserted the rugger sealing
washer with incorporated filter
(supplied with the machine) into
the hose collar. If the water
connection is made onto new
pipes or onto pipes which have
not been used for a long time, it