BDS MABasic 200 Original Betriebsanleitung - Seite 10
Blättern Sie online oder laden Sie pdf Original Betriebsanleitung für Bohrer BDS MABasic 200 herunter. BDS MABasic 200 20 Seiten.
Auch für BDS MABasic 200: Übersetzung der Originalbetriebsanleitung (20 seiten)
Seite drucken
Preparation
Check the condition
of the substrate
The magnetic clamping force is dependent
on the condition of the substrate. The clamp-
ing force is significantly reduced by paint,
zinc and scale coatings and rust.
The substrate must satisfy the following con-
ditions in order to achieve sufficient magnetic
clamping force:
■
The substrate must be magnetic.
■
The clamping surface and the magnetic
foot (8) must be clean and grease-free.
■
The clamping surface must be complete-
ly smooth and level.
NOTE
►
Clean the substrate and the magnetic
foot (8) of the machine before use.
►
Remove any unevenness and loose
rust from the substrate.
►
The BDS range of accessories in-
cludes special holding devices.
The best clamping effect is obtained on low-
carbon steel substrate with a thickness of at
least 20 mm.
Steel with low thickness
When drilling into low thickness steel, an
additional steel plate (minimum dimensions
100 x 200 x 20 mm) must be placed under
the workpiece. Secure the steel plate to
prevent it from falling.
10
NF metals or workpieces with an uneven
surface
A special holding device must be used when
drilling into NF metals or into workpieces with
an uneven surface.
NOTE
►
BDS offers a range of accessories with
special clamping devices for tubes and
non-magnetic materials.
Inserting the tool
WARNING
Risk of injury
►
Do not use damaged, soiled or worn
tools.
►
Change tools only when the machine
is switched off and at a standstill. Pull
the plug out of the mains socket.
►
After inserting, check that the tool is
engaged securely.
►
Only use tools, adapter and accesso-
ries that match the machine.
MABasic 200, 400, 450, 850
GB