BDS MABasic 200 Original Operating Instructions - Page 10
Browse online or download pdf Original Operating Instructions for Drill BDS MABasic 200. BDS MABasic 200 20 pages.
Also for BDS MABasic 200: Translation Of The Original Operating Instructions (20 pages)
Print Page
Preparation
Check the condition
of the substrate
The magnetic clamping force is dependent
on the condition of the substrate. The clamp-
ing force is significantly reduced by paint,
zinc and scale coatings and rust.
The substrate must satisfy the following con-
ditions in order to achieve sufficient magnetic
clamping force:
■
The substrate must be magnetic.
■
The clamping surface and the magnetic
foot (8) must be clean and grease-free.
■
The clamping surface must be complete-
ly smooth and level.
NOTE
►
Clean the substrate and the magnetic
foot (8) of the machine before use.
►
Remove any unevenness and loose
rust from the substrate.
►
The BDS range of accessories in-
cludes special holding devices.
The best clamping effect is obtained on low-
carbon steel substrate with a thickness of at
least 20 mm.
Steel with low thickness
When drilling into low thickness steel, an
additional steel plate (minimum dimensions
100 x 200 x 20 mm) must be placed under
the workpiece. Secure the steel plate to
prevent it from falling.
10
NF metals or workpieces with an uneven
surface
A special holding device must be used when
drilling into NF metals or into workpieces with
an uneven surface.
NOTE
►
BDS offers a range of accessories with
special clamping devices for tubes and
non-magnetic materials.
Inserting the tool
WARNING
Risk of injury
►
Do not use damaged, soiled or worn
tools.
►
Change tools only when the machine
is switched off and at a standstill. Pull
the plug out of the mains socket.
►
After inserting, check that the tool is
engaged securely.
►
Only use tools, adapter and accesso-
ries that match the machine.
MABasic 200, 400, 450, 850
GB