Anchor Explorer PA-2500 Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner Anchor Explorer PA-2500 herunter. Anchor Explorer PA-2500 7 Seiten.
Seite drucken
Getting Started
Inspection and inventory of your system
Check unit carefully for damage which may have occurred
during transit. Each Anchor product is carefully inspected at
the factory and packed in a special carton for safe transport.
Save the
Inventory
shipping carton
and packing
• Explorer sound system
materials. They
• Speaker stand adapter
were specially
designed to
• Warranty registration card
ship your unit
All damage claims must be made with the freight carrier.
safely.
Notify the freight carrier immediately if you observe any
damage to the shipping carton or product. Repack the unit
in the carton and await inspection by the carrier's claim agent.
Notify your dealer of the pending freight claim.
Returning your unit for service or repairs
Should your unit require service, contact your dealer or our
Customer Service Department at (310) 784-2300 to obtain a
Return Authorization (RA) number. All shipments to Anchor
must include an RA number and must be shipped prepaid.
C.O.D. shipments will be refused and returned at your cost.
Warranty registration
Please fill out the warranty card and return it with a copy of
your invoice to Anchor's Customer Service Department. This
will activate your limited two year warranty.
4
Wireless Operation
Replacing the transmitter battery
Note: The transmitter power switch must be in the OFF position!
HANDHELD: Unscrew the battery compartment cover on
the lower end of microphone. Install a fresh 9 Volt alkaline
battery* and replace the cover.
*Duracell
MN1604 or
BODY-PACK: Press the "OPEN" end of the battery cover,
equivalent.
slide it back and lift the cover. Install a fresh 9 Volt alkaline
battery* being sure to observe proper polarity. Close the cover.
Operating the wireless microphone system
The audio signal from the built-in wireless receiver is fed to
the Mic 2/Wireless input. Unplug any other mic from the
MIC 2 input when using the wireless system.
Operating the wireless microphone system:
1. Set the Mic 2/Wireless volume control to minimum.
MIC 2 /
WIRELESS
2. Turn the sound system power switch ON.
3. Slide the transmitter power switch to PWR.
The sound system's TX ON indicator
lights to indicate wireless signal (RF)
is being transmitted and received.
4. Adjust the Mic 2/Wireless control to desired volume.
Caution: Harmful feedback may occur when walking in front of a
sound system or speaker with a wireless microphone. Always point
mic away from speakers.
Using the microphone ON/MUTE switch:
ON
When set to the "ON" position the mic operates normally.
To prevent unwanted sounds from being picked up without
MUTE
turning the transmitter off, move switch to "MUTE" position.
(The handheld mic/transmitter comes with a protective
sleeve which fits over the power and mute switches to prevent
accidental movement during use. To install it, unscrew the
battery cover and slide the sleeve onto the microphone handle.
Replace the cover.)
(wireless model only)
TX ON
CA
9