Anchor Explorer PA-2500 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pembicara Anchor Explorer PA-2500. Anchor Explorer PA-2500 7 halaman.

Halaman Cetak

Getting Started

Inspection and inventory of your system

Check unit carefully for damage which may have occurred

during transit. Each Anchor product is carefully inspected at

the factory and packed in a special carton for safe transport.

Save the

Inventory

shipping carton

and packing

• Explorer sound system

materials. They

• Speaker stand adapter

were specially

designed to

• Warranty registration card

ship your unit

All damage claims must be made with the freight carrier.

safely.

Notify the freight carrier immediately if you observe any

damage to the shipping carton or product. Repack the unit

in the carton and await inspection by the carrier's claim agent.

Notify your dealer of the pending freight claim.

Returning your unit for service or repairs

Should your unit require service, contact your dealer or our

Customer Service Department at (310) 784-2300 to obtain a

Return Authorization (RA) number. All shipments to Anchor

must include an RA number and must be shipped prepaid.

C.O.D. shipments will be refused and returned at your cost.

Warranty registration

Please fill out the warranty card and return it with a copy of

your invoice to Anchor's Customer Service Department. This

will activate your limited two year warranty.

Wireless Operation

Replacing the transmitter battery

Note: The transmitter power switch must be in the OFF position!

HANDHELD: Unscrew the battery compartment cover on

the lower end of microphone. Install a fresh 9 Volt alkaline

battery* and replace the cover.

*Duracell

MN1604 or

BODY-PACK: Press the "OPEN" end of the battery cover,

equivalent.

slide it back and lift the cover. Install a fresh 9 Volt alkaline

battery* being sure to observe proper polarity. Close the cover.

Operating the wireless microphone system

The audio signal from the built-in wireless receiver is fed to

the Mic 2/Wireless input. Unplug any other mic from the

MIC 2 input when using the wireless system.

Operating the wireless microphone system:

1. Set the Mic 2/Wireless volume control to minimum.

MIC 2 /

WIRELESS

2. Turn the sound system power switch ON.

3. Slide the transmitter power switch to PWR.

The sound system's TX ON indicator

lights to indicate wireless signal (RF)

is being transmitted and received.

4. Adjust the Mic 2/Wireless control to desired volume.

Caution: Harmful feedback may occur when walking in front of a

sound system or speaker with a wireless microphone. Always point

mic away from speakers.

Using the microphone ON/MUTE switch:

When set to the "ON" position the mic operates normally.

To prevent unwanted sounds from being picked up without

MUTE

turning the transmitter off, move switch to "MUTE" position.

(The handheld mic/transmitter comes with a protective

sleeve which fits over the power and mute switches to prevent

accidental movement during use. To install it, unscrew the

battery cover and slide the sleeve onto the microphone handle.

Replace the cover.)

(wireless model only)

TX ON