Anchor Navi-Trac LT/CS Installationsanleitung Handbuch - Seite 10

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Zelt Anchor Navi-Trac LT/CS herunter. Anchor Navi-Trac LT/CS 16 Seiten. Pavilion 12' to 24' projection

Seite drucken

Step 4 - Joining Beam Arches

Join in the order listed: (Figure 4a)

•

Front Eave - slide one end of front eave tube onto end eave weldment with bottom channel down. Align holes and pin

with one of the pins attached to the weldment. Figure 4b.

•

Gable End Mid Eave - drop gable end mid eave into brackets on upright rear upper splices. Figure 4c

•

Ridge - ﬁ t ridge into slots provided in ridge weldment. Figure 4d.

•

Purlin - Drop curved end of purlin into rafter bracket. See ﬁ gures 4e and 4f. Drop square hook end into the correspond-

ing rafter bracket.

•

Note: If optional installation kit has been used, remove eyenut at lower end of ﬁ rst rafter and replace with nut

before snapping cables in place.

Note: If Installation Kit has been purchased, the short lifting bar may be used to lift bars into place.

•

Snap lower ends of cables onto their respective eye nuts. Square up frame by tightening turnbuckles

Parts labeled numerically in

the order to be installed.

22' Projection Frame Shown

Gable End

Mid Eave

Frame sizes under 16'

projection have only (2)

cables per bay and no

purlins.

Longer

Front Eave

Ridge

Rafter

Figure 4b

Purlin

Upright Rear

Upper Splice

Gable End Mid

Eave

Front Eave

Frame attaching

bracket.

Eave Projection

Figure 4a

Figure 4c