Anchor Navi-Trac LT/CS Installationsanleitung Handbuch - Seite 11

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Zelt Anchor Navi-Trac LT/CS herunter. Anchor Navi-Trac LT/CS 16 Seiten. Pavilion 12' to 24' projection

Seite drucken

Ridge

Step 4 - Cont'd

Continue raising beams and attaching them until frame is completely assembled. Connect all cables and tighten. Measure to

be sure frame is square and in proper position.

Step 5 - Fabric Mid Installation

•

With one installer at top of each rafter, feed eave end of kedar into top channel opening of ridge weldment and down into

rafter. (Figure 5a) Feed both kedars at the same time and at the same rate until the ends of the kedars are at end of raf-

ter at eave. Optional method: Snap pull ropes onto pull rings at mid eaves and pull mids down from top after kedars are

started into channels simultaneously.

•

Raise back ends of mid kedars up until bottom of kedar can be fed down into top of channel on Upright Rear Upper

Splice. Feed both kedars down at the same time and at the same time until kedars are fully inserted into channels. (Fig-

ure 5b)

•

Continue this process until all mids are installed.

Pull Ring at

Mid Eave

Mid

Ridge

Weldment

Rafter

Ridge Weldment

Eave end of kedar

Front curtain

folded back onto

top of mid

Curved hook end

Figure 4d

Ridge of adjacent bay

Rafter

Upright Rear

Upper Splice

Figure 5a

Square hook end

Purlin

Rafter

Mid

Kedar feed-

ing down into

channel

Figure 4e

Purlin

Figure 4f

Figure 5b