Electrolux AUCI Handbuch - Seite 14
Blättern Sie online oder laden Sie pdf Handbuch für Geschirrspüler Electrolux AUCI herunter. Electrolux AUCI 16 Seiten. Undercounter dishwasher
Auch für Electrolux AUCI: Handbuch für Installation, Betrieb und Wartung (20 seiten)
Seite drucken
How to fill the salt container
•
Switch off the dishwasher by pressing button "A"
(Figure 17).
•
Unscrew cap "A" (Figure 25) of the salt container,
turning it anticlockwise.
A
Figure 25
•
Pour approx. 1.5 kg of coarse salt [NaCl] in container
"A" (an amount sufficient to fill the salt container up to
the rim) using the special funnel supplied (Figure 26).
NaCl
(1,5 kg)
Figure 26
IMPORTANT:
!
only salt may be placed in the salt con-
tainer. Do not introduce any other chem-
ical substances such as detergent, rinse
aid or descaling agent, since these
would inevitably damage the appliance.
Such damage invalidates any warranty
and relieves the manufacturer of all lia-
bility.
•
Remove any traces of salt from the filling hole, the
container thread and the closing cap seal.
16
•
Refit the cap of container "A", turning it clockwise
and making sure it is tight.
IMPORTANT:
!
The messages
can appear,
even after adding the salt, since the salt
must circulate in the entire system. Cor-
rect operation of the dishwasher is not,
however, affected.
The salt container always has water in it, therefore it is
normal if water comes out during filling.
C6
WARNING MESSAGES DISPLAYED ON THE
CONTROL PANEL
A1
NO WATER
-
Check that the cock is open
-
Check that the water inlet filter is clean
-
Check the minimum mains pressure (not less than
50 kPa)
-
Check that the overflow pipe is inserted (for
appliances without drain pump only)
B1
INEFFICIENT DRAINAGE
-
Check if the overflow has been removed.
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
B2
TANK WATER LEVEL TOO HIGH
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
C1..C8
CALL THE SERVICE CENTRE
E1..E8
CALL THE SERVICE CENTRE
-
The appliance continues to operate, but appro-
priate checks by a technician are recommended.
CALL THE SERVICE CENTRE
F21..F22
SAL 0
SAL END
or
for several wash cycles,