Dreamiracle HIM-35B Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Eiswürfelbereiter Dreamiracle HIM-35B herunter. Dreamiracle HIM-35B 12 Seiten.

CONTROL PANEL OPERATION

ON/OFF/CLEAN: Power switch button/Cleaning function button

SELECT: Mode selection button

ICE FULL: Ice full alarm indicator

ADD WATER: Water shortage alarm indicator

CLEAN: Automatic Cleaning mode indicator

LARGE: Large ice indicator

SMALL: Small ice indicator

1) Press the "ON/OFF" button on the LED Control Panel to begin the

ice-making cycle.

Note: Once started, you cannot press the "ON/OFF"

button again to stop it. You must wait 30 seconds to allow the unit to melt

the unﬁnished ice cube. Also, while unit is running, you can press the

"ON/OFF" button to turn it off, but you cannot press the "ON/OFF" button

immediately to restart unit - you must wait 1 minute to allow unit to get

back into position while protecting compressor.

2) Press the "SELECT" button to select large ice and small ice modes. When

the indoor temperature is lower than 15°C(59°F), small ice is recommended.

When the indoor temperature is higher than 30°C(86°F), large ice is

recommended.

3) CLEANING FUNCTION

Plug in the power, hold the "CLEAN" button for 3 seconds to start up the

cleaning function. The "CLEAN" indicator will light up, and the pump will

start to pump water and keep running for 6 minutes, and it will automati-

cally enter into the ice-making mode after running for 6 minutes, ﬁnally,

open the drain plug and empty the water.

4) ADD WATER: water shortage alarm

When the "ADD WATER" light turns red, it means that there is water

shortage in the water tank. You need to add water and press the "ON/OFF"

button to restart the machine.

5) ICE FULL: Ice full alarm

When the ice reaches the maximum capacity of the ice storage container,

the "ICE FULL" light ﬂashes, and the machine stops. At this time, the ice

needs to be poured out. When the ice position is lower than the full sensor

position, the machine will restart automatically.