Dreamiracle HIM-35B User Manual - Page 6
Browse online or download pdf User Manual for Ice Maker Dreamiracle HIM-35B. Dreamiracle HIM-35B 12 pages.
Print Page
CONTROL PANEL OPERATION
ON/OFF/CLEAN: Power switch button/Cleaning function button
SELECT: Mode selection button
ICE FULL: Ice full alarm indicator
ADD WATER: Water shortage alarm indicator
CLEAN: Automatic Cleaning mode indicator
LARGE: Large ice indicator
SMALL: Small ice indicator
1) Press the "ON/OFF" button on the LED Control Panel to begin the
ice-making cycle.
Note: Once started, you cannot press the "ON/OFF"
button again to stop it. You must wait 30 seconds to allow the unit to melt
the unfinished ice cube. Also, while unit is running, you can press the
"ON/OFF" button to turn it off, but you cannot press the "ON/OFF" button
immediately to restart unit - you must wait 1 minute to allow unit to get
back into position while protecting compressor.
2) Press the "SELECT" button to select large ice and small ice modes. When
the indoor temperature is lower than 15°C(59°F), small ice is recommended.
When the indoor temperature is higher than 30°C(86°F), large ice is
recommended.
3) CLEANING FUNCTION
Plug in the power, hold the "CLEAN" button for 3 seconds to start up the
cleaning function. The "CLEAN" indicator will light up, and the pump will
start to pump water and keep running for 6 minutes, and it will automati-
cally enter into the ice-making mode after running for 6 minutes, finally,
open the drain plug and empty the water.
4) ADD WATER: water shortage alarm
When the "ADD WATER" light turns red, it means that there is water
shortage in the water tank. You need to add water and press the "ON/OFF"
button to restart the machine.
5) ICE FULL: Ice full alarm
When the ice reaches the maximum capacity of the ice storage container,
the "ICE FULL" light flashes, and the machine stops. At this time, the ice
needs to be poured out. When the ice position is lower than the full sensor
position, the machine will restart automatically.
05