Dreamiracle HIM-35B User Manual - Page 8
Browse online or download pdf User Manual for Ice Maker Dreamiracle HIM-35B. Dreamiracle HIM-35B 12 pages.
TROUBLESHOOTING
1. Please note, if a power failure occurs due to disconnection of the power
cord, or the power button has been pushed off during an ice making
cycle, small ice chips may form and lodge in the automatic shovel
causing it to jam. If this occurs, the ice chips may be removed by
disconnecting the power cord and gently pushing the shovel to the rear
of the cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not
remove the ice to the ice basket. If not, please push the ice shovel gently
by finger, then press ON/OFF button to restart.
PROBLEM
The compressor works
abnormally with a
buzzing noise
Water shortage
indicator light is on
Indicator lights on
display are not on
The ice made is too
large and with pieces
sticking together
The ice making
process was correct,
but no ice came out?
All indicators twinkle
simultaneously
The machine has
been working, but the
water has been
warming
When the ice is full,
the machine does not
display the ICE FULL
Icon.
POSSIBLE CAUSE
The voltage is lower than
recommended.
1.There is no water.
2.The pump is full of air.
Blown fuse/ No power.
Ice of previous cycles left
in the water tray.
1.The compressor has no
refrigerant.
2.Compressor damaged.
3.Fan motor damaged.
1.Water tray is blocked by
ice cube.
2.The motor is stuck, or
the motor falls off, or the
motor is damaged.
3.The micro switch was
destroyed.
Solenoid broke down.
Ice full sensor damaged
Sunlight interference.
07
SUGGESTED SOLUTIONS
Stop the Ice maker and do
not restart until the voltage is
normal.
1.Add to some water until it
reaches MAX position.
2.Press POWER button to
restart.
Replace fuse / Turn power on.
Take out the ice under the
standby state.
Call the service hotline.
1.Unplug the power to take
out the ice which blocking
the tray, then plug the power
and press the POWER
button, the machine will
restart 3minutes later.
2.Call the service hotline.
Replace the solenoid valve.
1.Replace the ice full sensor.
2.Making ice indoor.
3.Call the service hotline.