Electrolux 10 GN2/1 Installationshandbuch - Seite 15
Blättern Sie online oder laden Sie pdf Installationshandbuch für Gefrierschrank Electrolux 10 GN2/1 herunter. Electrolux 10 GN2/1 34 Seiten. Electrical combi oven, touch and digital
Auch für Electrolux 10 GN2/1: Handbuch (3 seiten)
Seite drucken
A.6
Transport, handling and storage
• Transport (i. e. transfer of the appliance from one place to another) and handling (i. e.
transfer inside workplaces) must occur with the use of special and adequate means.
• Please refer to indications on packaging for stackability during transport, handling and
storage.
• Do not stand under suspended loads during loading or unloading operations.
Unauthorized personnel must not enter the work area.
• The weight of the appliance alone is not sufficient to keep it steady.
• For appliance handling, do not lift and anchor it to movable or weak parts such as:
casings, electrical raceways, pneumatic parts, etc.
• Do not push or pull the appliance to move it, as it may tip over. Use proper tool to lift the
appliance.
• Arrange a suitable area with flat floor for appliance unloading and storage operations.
• Appliance transport, handling, shifting and storage personnel must be adequately
instructed and trained regarding the safely use of lifting systems and personal protection
equipment suitable for the type of operation carried out.
• When removing the anchoring systems, make sure the stability of the appliance parts
does not depend on the anchoring and, therefore, that this operation does not cause the
load to fall off the vehicle. Before unloading the appliance components, make sure all
the anchoring systems are removed.
A.7
Installation and assembly
Install the appliance in compliance with the current local and national regulations.
• The operations described must be carried out in compliance with the current safety
regulations and provisions in force in the country of use.
• The appliance is not suitable for installation outdoors and/or in places exposed to
atmospheric agents (rain, direct sunlight, etc.).
A.8
Electrical connection
• The power supply system must be suitable for the rated current of the connected
appliance; the connection must be carried out in compliance with the regulations and
provisions in force in the country of use.
• The information regarding the appliance power supply voltage and frequency is given on
the data plate.
• Install between the power cable and the electric line a differential thermal-magnetic
switch suitable for the absorption specified on the data plate, with contact gap enabling
complete disconnection in category III overvoltage conditions and complying with the
regulations in force.
For the correct sizing of the switch or plug, refer to the absorbed current specified on the
appliance data plate.
• If the power cable is damaged or too short, it must be replaced by the Customer Care
Service or in any case by specialised personnel, in order to prevent any risk.
• The manufacturer declines any liability for damage or injury resulting from breach of the
above rules or non-compliance with the electrical safety regulations in force in the
country where the appliance is used.
• Verify that a safety circuit breaker is installed between the power cable of the appliance
and the mains electric line. The contact opening max. distance and leakage current
must comply with the local safety regulations.
15