Electrolux 10 GN2/1 Installationshandbuch - Seite 16
Blättern Sie online oder laden Sie pdf Installationshandbuch für Gefrierschrank Electrolux 10 GN2/1 herunter. Electrolux 10 GN2/1 34 Seiten. Electrical combi oven, touch and digital
Auch für Electrolux 10 GN2/1: Handbuch (3 seiten)
Seite drucken
A.9
Water connection
• Water connection must be carried out in compliance with the regulations and
provisions in force with the country.
• The pressure measured upstream of the oven (and downstream of any WATER
FILTRATION SYSTEMS installed) must be between 100 – 600 kPa (1,0 – 6,0 bar / 14,5
– 87psi) measured in dynamic conditions, i.e. during the boiler filling and washing phase.
WARNING
The manufacturer declines any liability if the safety regulations are not
respected.
A.10
Positioning
• Install the appliances, taking all the safety precautions required for this type of operation,
also respecting the relevant fire-prevention measures.
• Handle the appliance with care in order to avoid damage or danger to people. Use a
pallet for handling and positioning.
• The installation diagram gives the appliance overall dimensions and the position of
connections (gas, electricity, water). Check that they are available and ready for making
all the necessary connections.
• Check and, if necessary, level the appliance after positioning. Incorrect levelling can
cause appliance malfunctioning.
• In case of "Marine" models, the appliances must be fixed to the floor.
• Prevent the areas where the appliance is installed to be polluted with corrosive
substances (chlorine, etc.). The manufacturer declines any liability for corrosive effects
due to external causes.
A.11
Appliance space limitations
• The appliances are not suitable for recess-mounting. Leave a space of at least 50 mm
between the appliance and right side and rear walls and 500 mm from the left wall, or in
any case an adequate space to enable subsequent servicing or maintenance operations.
• Maintain a distance of at least 100 mm between the appliance and any combustible
walls.
A.12
Appliance disposal
• Make the appliance unusable by removing the power cable and any compartment
closing devices, to prevent the possibility of someone becoming trapped inside.
B
APPLIANCE AND MANUFACTURER'S IDENTIFICATION DATA
B.1
Dataplate position
This instruction manual contains information relevant to various appliances.
See the dataplate located on the left side to identify the appliance (see the picture below).
16