Andersen 40 ST FS Produkthandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Produkthandbuch für Winden Andersen 40 ST FS herunter. Andersen 40 ST FS 8 Seiten.
Auch für Andersen 40 ST FS: Handbuch (6 seiten), Handbuch (9 seiten)

Seite drucken

SERVICE INSTRUCTIONS

Tools required for service:

• Allen key (4 mm)

• Screwdriver (medium)

1. Remove screw (1) and top cap (2).

2. Remove self-tailing arm (3) and drum (5).

3. Insert a winch handle. Pull up the drive shaft (6) gently, while turning gear wheel (15)

and ratchet gear (12) carefully. Remove drive shaft (6).

4. Remove plugs (6.4), pawls (6.3) and arm springs (6.2).

5. Remove ratchet gear (12) and bushing (11).

6. Remove ratchet gear (13).

7. To release the roller bearing (7), gently insert a small screwdriver between roller bearing

and base (16). Remove roller bearing (7).

8. Remove shaft (14) and gear wheel (15). Use a screwdriver.

9. Clean all parts in white spirits/mineral spirits. Remember to clean the gear teeth.

10. Assemble in reverse order. During assemble, by the use of a small soft brush lightly grease

all gear teeth, drive shaft, roller bearing, shafts, pawls, springs and bushings. Pawls should

only be lubricated with a very thin film of ANDERSEN WINCH GREASE. It is very important

that pawls can move freely.

IMPORTANT: When assembling the winch, check the functioning of each pawl by pushing

the pawl against the spring. The pawls should move smoothly and automatically return to

their normal position, where the pawls engage with the teeth. If the pawls do not function

correctly, clean and lubricate the pawls and gears. Check the function of the pawls again to

make sure that it works correctly. If the pawls do not work correctly replace the springs and

recheck the functioning.

Malfunctioning pawls may lead to unexpected release of the winch force resulting in fatal

injuries to the user and others.

Service Kit No: 1 (part. no. 710001) contains spare parts for this winch.

Maintenance instructions for PVD coated stainless steel surfaces.

PVD-coated surfaces should be rinsed regularly in fresh water to remove any salt residue, dirt

or other contaminants and dried gently with a soft cloth. To remove grease or other marks,

a mild abrasive free cleaning agent such as spray-on glass cleaning solution may be used.

No caustic detergents or other aggressive or abrasive cleaning agents

should ever be used, as they may damage the surface.

40ST (V.5.0)

40ST FS (V.5.0.F)

• Winch handle

• ANDERSEN winch grease