Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor Betriebs-/Sicherheitshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Betriebs-/Sicherheitshandbuch für Bohrer Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor herunter. Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor 33 Seiten. Bosch demolition hammer parts list
Auch für Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor: Kurzreferenz-Handbuch (25 seiten), Betriebs-/Sicherheitshandbuch (29 seiten), Teileliste (2 seiten), Betriebliche Informationen (3 seiten), Betriebs-/Sicherheitshandbuch (33 seiten)

Seite drucken

Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor Betriebs-/Sicherheitshandbuch

2610048701.qxp_DH712VC 10/5/17 8:01 AM Page 8

AUXILIARY HANDLE

The tool must be supported with the auxiliary

handle, which can be swiveled 360˚. To

reposition and/or swivel the handle, loosen the

lock knob, move the handle to the desired

position along the barrel and securely retighten

the lock knob (Fig. 2).

INSTALLING ACCESSORIES

Clean the insert shank end of the accessory to

remove any debris, then lightly grease with a

light oil or lubricant.

Insert accessory into the tool holder through

the dust shield, while twisting and pushing

inward until it locks automatically into place.

Pull outward on the accessory to be certain it is

locked into the tool holder (Fig. 3).

NOTE: The high efficiency available from the

hammers can only be obtained if sharp and

undamaged accessories are used. The "cost"

FIG. 3

TRIGGER "ON-OFF" SWITCH

Your tool is equipped with a "Lock-ON" feature

which allows continuous operation without

holding the trigger.

TO LOCK TOOL "ON":squeeze the trigger

switch until it locks (Fig. 5).

TO TURN TOOL: "OFF" press the trigger

release switch and the trigger will return to the

"OFF" position automatically (Fig. 5).

Assembly

DUST SHIELD

Operating Instructions

FIG. 2

LOCK KNOB

maintain

sharp

accessories is more than offset by the "time

saved" in operating the tool with sharp

accessories.

REMOVING ACCESSORIES

Accessories may be hot

after use. Avoid contact

with skin and use proper protective gloves or

cloth to remove.

To remove an accessory, pull locking sleeve

backward and pull bit forward. All accessories

should be wiped clean after removing (Fig. 4).

FIG. 4

To increase switch life, do not turn switch on

and off while tool is under load.

TRIGGER

SWITCH

RELEASE SWITCH

-8-

AUXILIARY

HANDLE

and

undamaged

LOCKING

SLEEVE

TRIGGER

FIG. 5